INIM Electronics AIR2 KF100 Installation And Programming Manual
Text of the manual
������ ������� ����
�������������� ����
EN 50131-1
EN 50131-5-3
EN 50130-4
EN 50130-5
������������ ��� ����������� ������
Table of contents
1. Air2 system description
3
2. Description remote control keys Air2
4
2.1 Description of parts
4
2.2 Technical specifications of remote-control keysAir2
5
2.3 Remote-control key notificationsAir2
5
3. Installation of remote-control keys Air2
7
3.1 Enrolling a wireless device
7
3.2 Battery replacement
7
4. General information
8
4.1
KF100, Pebble, Ergo | © 2020 Inim Electronics S.r.l.
3
1. Air2 system description
All anti-intrusion systems INIM can manage the two-way wireless system Air2 characterized by a MHz carrier
frequency 868 MHz.
The system components Air2 are:
Air2-BS200/50 transceiver module, 50 terminals
Air2-BS200/30 transceiver module, 30 terminals
Air2-BS20
2. Description remote control keys Air2
2. Description remote control keys Air2
The remote-control key Air2 has 4 buttons which can be programmed from the control panel.
Each button can be associated with a control panel shortcut, which can be activated by pressing the button
and is confirmed by a beep from the remote-control buzzer.
Furthermore, if the �
KF100, Pebble, Ergo | © 2020 Inim Electronics S.r.l.
5
2.2 Technical specifications of remote-control keysAir2
2.2 Technical specifications of remote-control key-
sAir2
Model
Air2-KF100
Air2-Pebble
Air2-Ergo
Battery
Lithium CR2032 3V
“Low battery” fault voltage
< 2,12V
Current draw
during standby
350 nA
maximum
36 mA
Buzzer
Multitone
Operating envir
2. Description remote control keys Air2
The buzzer signal remains in order to distinguish whether the operation was carried out successfully or was
unsuccessful.
6
Installation and programming manual- 100-DRAFT
KF100, Pebble, Ergo | © 2020 Inim Electronics S.r.l.
7
3.1 Enrolling a wireless device
3. Installation of remote-control keys Air2
The Air2 requires enrolling only.
If it becomes necessary to replace the rubber button cover or battery, work through the following steps:
1. Remove the enclosure screw on the back of the remote-control key and open the devic
4. General information
4. General information
4.1 About this manual
Manual code: DCMIINE0A2KF8E
Revision: 100-DRAFT
Copyright: The information contained in this document is the sole property of Inim Electronics S.r.l.. Copy-
ing, reprinting or modification of this document, in part or as a whole, is not permitted without prior autho-
rization in writing f
KF100, Pebble, Ergo | © 2020 Inim Electronics S.r.l.
9
4.5 Documents for the users
4.5 Documents for the users
Declarations of Performance, Declarations of Conformity and Certificates concerning to Inim Electronics
S.r.l. products may be downloaded free of charge from the web address www.inim.biz, getting access to
Extended Access and then selecting "Cert