Ignis Pixel v3 Manual
Text of Ignis Pixel v3 Manual
Manual to iPixel v3.
Available for the firmware version 3.0.5 and further.
Control elements.
The device has three control buttons for navigation: “UP”, “DOWN”, “PLAY/STOP”.
“UP” and “DOWN” buttons navigate over the menu, shift images in single image mode. Besides,
keeping the “DOWN” button pressed in play mode puts the device into performance preparation mode.
Operating conditions.
The device can be in following conditions:
▪
Turn
To turn it off press and hold “PLAY/STOP” button not less than for 1 second. LEDs successively go out
from top to bottom.
After the turned off device is plugged in to the charger or a PC, the battery indicator lights up. The red
indicator shows the device is being charged, the green indicator shows the devise is charged.
To display the battery level press and hold the middle button of the turned on device for half a second
until a battery level scale a
Timeline mode is on the left figure, single image mode is on the right.
The device has protection from accidental touching the buttons during a performance. It allows to
protect your performance program from any faults. For this you should select a required mode (a
sequence or a single image), get it into play, and hold the “DOWN' button. In a second the device goes
into performance preparation mode. This mode is indicated by a single while light, showi
Radio channel operation.
The devices can synchronize their modes with each other, as well as be operated from remote controls.
It allows to start and stop different devices in different modes simultaneously.
Radio can be turned off, if synchronization of the device is not required. On default radio is on, total
control mode is off, group work mode is on, slave mode is not active.
There are several principal modes for radio operation in the device:
1. Radio
Total control, group work, and slave modes can be activated simultaneously, thereby giving space for
flexible settings of the devices and having complete access to all devices of the group, not interfering
into the work of other devices.
A quick way to switch total control mode is provided for. Being in timeline mode or single image mode,
press and hold both “UP” and “DOWN” buttons for 1 second. Blinking menu serves as a sign that the
mode has been
Sequences and pictures loading.
Pictures are to be uploaded through the Ignis Pixel Utility.
The device places up to 80 pictures and up to 10 timelines (sequences).
Settings of the device and status of the system.
Through the system menu some parameters can be adjusted, as well as the state of the device can be
checked out.
You can adjust parameters of the radio, choose a group the device belongs to, set the brightness of the
performance preparation mode indicator.
To enter into system menu press and hold “UP” and “DOWN” buttons for 5 seconds until indication
changes.
Description of the points of system menu c
Appendix 1. Description of the points of system menu:
If the indication is red – the parameter is not active, if green – it's active.
System menu is arranged into basic menu and several submenus.
Examples of the indication in the system menu.
From left to right:
▪
indication in the basic system menu, the cursor is on the first submenu;
▪
indication in the basic menu, the cursor is on the third submenu;
▪
the first submenu, total control mode is a
Description of the points in the basic system menu.
1. Status and settings of the radio;
2. Choosing of a radio channel;
3. Choosing of a group;
4. Brightness of the performance preparation indicator;
5. System condition.
Description of the points in the submenu.
Submenu 1 – status and settings of the radio.
1. Radio availability;
2. Turning on/off radio;
3. Total control mode;
4. Group work;
5. Not used, reserved;
6. Master/slave;
7. Not used, reserved