ATC 2002WF Operation & User’s Manual

Version20060502 2 Quick Start 1 - READ THIS! Things You Need to Know That are Not Obvious: This section explains what the Switch, LEDs, etc. do. 1 “Configuration” switch: The slide switch located on the rear of the Serial Server must be switched “up” to the “Config. Mode” to use the Set Up Utility. This switch ...

More Things You Need to Know That are Not Obvious: This section explains the basics of Starting Configuration. To configure the Serial Device: 1 Load the Set UP Utility from the CD, It should auto-install upon inserting CD to a PC. 2 Plug in the Power Supply into the Power Jack. (You may not need the power supply to config ...

responsibility for any errors, which may appear in this guide. Ethernet is a trademark of XEROX Corporation. Microsoft, Windows and Windows logo are trademarks of Microsoft Corporation. It should be declared that this 802.11g wireless to Serial Server is limited in CH1~CH11 ...

Version1.00 5 responsible for compliance could void the user’s authority to operate the equipment. CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Prohibition of co-location This device and its antenna(s) must ...

Version1.00 6 1. Introduction The RS232 connection application has used for a long time. RS232 cable has limitations in distance. WLAN (Wireless Local Area Network) has become a worldwide standard protocol for wireless applications. There are many applications for using RS232 connection over WLAN, including POS, data captur ...

Version1.00 7 Converter over the Internet The application is used for far end remote communication via the Internet. Note: For environments requirement, applications listed above might require the 802.11x protocol and proprietary IP (or TCP/IP) protocol. 1.2 Package Content � One 802.11g Wireless to Serial Server � One ...

Version1.00 8 LED Indication WLAN Blinks green to indicate data is transmitting and receiving. SYSTEM Off to indicate system is in initial status and the converter not ready to operate. Lights yellow to indicate system is in communication mode. Blinks to indicate system is in configuration mode. TD Lights red to indicate th ...

Version1.00 9 Configuration Switch “Config Mode”: Moving the switch up to Config Mode will allow the User to configure the Server using the Set Up Utility software. “Communication Mode”: This is the “RUN” mode that allows the Server to wirelessly transmit data and receive data over the wireless network. COM 1 CO ...

Version1.00 10 3. Installation To start the installation, please follow the steps. 1. Insert the CD into the CD-ROM. 2. Select the setup file: setup.exe. Click “setup” to run the program. The following dialogue will appear. Click “Yes” to continue. 3. As entering the welcome screen, click “Next” to continue. 4. ...