Fluke Calibration 9500B Calibration Manual

All product names are trademarks of their respective companies. 9500B High Performance Oscilloscope Calibrator Calibration Manual ...

Each Fluke product is warranted to be free from defects in material and workmanship under normal use and service. The warranty period is one year and begins on the date of shipment. Parts, product repairs, and services are warranted for 90 days. This warranty extends only to the original buyer or end-user customer ...

Title Page Introduction ........................................................................................................... 1 Contact Fluke Calibration Calibration ................................................................... 1 Safety Information ............................................................................. ...

Introduction ....................................................................................................... 23 Parallel Port (Rear Panel) ................................................................. ...

Calibration Enable Switch ............................................................................ 78 Password ....................................................................................................... 79 Ca ...

9510/9530/9550/9560 Head Calibration Procedures ............................................. 118 Levelled Sine Function: LF Gain ...................................................................... 118 Levelled Sine Function: ...

capabilities from a single source, providing wide functionality (shown in Figure 1). (Variant 9500B/1100 is described—for other variants, refer to the 9500B Extended Specifations. See Specifications.) Erw001 Figure 1. General View of Model 9500B with ...

Calibration Calibration’s website at www.flukecal.com. To register your product, visit http://flukecal.com/register-product. Safety Information General Safety Information is located in the printed Safety Information document that ships with the Pro ...

Routine Maintenance 3 Once the cover is removed, holes can be seen in the chassis assembly right side, with the reticulated filter located over these holes, attached by four black nylon snap rivets through four holes to the chassis assembly. Inspect and clean the filter element by vacuuming at intervals of no more tha ...

1. Hold the filter element in position to cover the chassis holes, and the four securing holes. Separate the latch and center pin of a black nylon snap rivet, and push the latch through the filter into a securing hole at the top. Fit the center pin into the latch and push fully home, so that the pin ope ...