Fluke MicroScanner Pro Operation & User’s Manual

Text of Fluke MicroScanner Pro Operation & User’s Manual

November 2001, Rev. 2, 9/03

© 2001-2003 Fluke Corporation. All rights reserved. All product names are trademarks of their respective companies. Fluke Microtest Microscanner Pro Specs Provided by www.AAATesters.com

LIMITED WARRANTY AND LIMITATION OF LIABILITY

Each Fluke Networks product is warranted to be free from defects in material and workmanship under normal use and service. The warranty period is one year and begins on the date of purchase. Parts, accessories, product repairs and services are warranted for 90 days. This war- ranty extends only to the original buyer or end-user customer of a Fluke Networks authorized reseller, and does not apply to disposable ba

Table of Contents

Title Page Introduction.................................................................................................................... 1 Features.......................................................................................................................... 2 MICROSCANNER PRO Kit Content ........................................................................................ 2 Registration...................................

Network Link Indicator ........................................................................................... 14

Pair Length............................................................................................................. 17 Coaxial Cabling.........................................................................

MICROSCANNER PRO™ is an all-in-one network tester that

you can use to verify twisted pair and coaxial cables, measure length and distance to faults via TDR, and identify active networks and hubs. MICROSCANNER PRO aue28f.eps Figure 1. MicroScanner Pro

Tests unshielded twisted pair (UTP), shielded

twisted pair (SSTP) and coaxial cable • Pinpoints opens, shorts, crossed and split pairs • Measures cable length via TDR • Checks and verifies wiremap • Generates four different tracing tones to help identify users • Identifies active networking 10/100 hubs, switches, and PCs. MICROSCANNER PRO Kit Content Your MICROSCANNER PRO kit contains the following: �

Registering your product with Fluke Networks gives

you access to valuable information on product updates, troubleshooting tips, and other support services. To register, go to the Fluke Networks website at www.flukenetworks.com/registration and fill out the online registration form. If you do not have Internet access, print the registration form that is on the CD included with the product. Fill out the form, t

Contacting Fluke Networks

If you have technical questions, you may contact Fluke Networks’ Technical Support by phone, fax or e-mail. www.flukenetworks.com [email protected] +1-425-446-4519 • Australia: 61 (2) 8850-3333 or 61 3 9329 0244 • Beijing: 86 (10) 6512-3435 • Brazil: 11 3044 1277 • Canada: 1-800-363-5853 • Europe: +44 1923 281 300 • Hong Kong: 852 2721-3228 • Japan: +81-3-3434-0181 • Korea:

MICROSCANNER PRO requires a 9 Volt Alkaline battery.

The Battery icon is displayed on the screen when MICROSCANNER PRO detects a low battery condition. Using MICROSCANNER PRO with a low battery may effect the test accuracy. If MICROSCANNER PRO is stored for more than one month, the battery should be removed. Note MICROSCANNER PRO will not function properly with a 9 Volt Carbon Battery. The Keypad ON OFF When turned on,

Press MODE to select the desired test. The available

modes are: • WIREMAP • OFFICE IDENTIFIER • LENGTH • TONER Calibration Mode MODE + ON OFF Turn the MICROSCANNER PRO OFF, then hold the MODE key down while pressing the ON key to start Calibrate mode. Use MICROSCANNER PRO to calibrate cable lengths of more than 50 feet (15 meters) and up to 1500 feet (457 meters). Setting the NVP percentage Once

Fluke Test Equipment Owners Instructions: