Clarke CON1200 Operating & Maintenance Instructions

Text of the manual

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]

INTRODUCTION Thank you for purchasing this CLARKE Hammer Drill. Before attempting to use the machine, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around yo

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]

TABLE OF CONTENTS INTRODUCTION ..................................................................................2 GUARANTEE ........................................................................................2 ENVIRONMENTAL PROTECTION ...............

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]

GENERAL SAFETY RULES WORK AREA 1. Keep the work area clean and well lit. Cluttered and dark areas invite accidents. 2. Do not operate power tools in explosive atmospheres such as in the presence of flammable liquids, gasses or dust. Power tools create spa

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]

5. Dress properly. Do not wear loose clothing or jewellery which may get caught in moving parts. Wear protective hair covering to contain long hair. For best footing, wear rubber soled footwear. Keep floor clear of oil, scrap wood, etc. 6. Concentrate on

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]

HAMMER DRILL SAFETY INSTRUCTIONS 1. Only use the hammer drill in the manner and for the functions described in these instructions. 2. Using the correct bit. Use the appropriate drill bit for the material being drilled. Different bits are available from yo

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]

ELECTRICAL CONNECTIONS WARNING! Read these electrical safety instructions thoroughly before connecting the product to the mains supply. Before switching the product on, make sure that the voltage of your electric- ity supply is the same as that indicate

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]

OVERVIEW The CLARKE CON1200 is a variable-speed drill, equipped with an adjustable speed controller, high and low gear selection and hammer operation and has a lock-on button for continuous operation. The drill is supplied with a depth stop rod and auxili

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]

OPERATION IMPORTANT: To avoid accidental starting, ensure the drill is switched OFF before plugging in to the mains. To do this, briefly pull the switch, and release to ensure the trigger lock is not set in the ‘lock’ position. INSERTING A DRILL BIT

Other Drill Manuals