Flowserve Valtek CavControl Trim Installation, Operation & Maintenance Instructions

Text of Flowserve Valtek CavControl Trim Installation, Operation & Maintenance Instructions

Valtek No. 10003460

15-1 Flowserve Corporation, Valtek Control Products, Tel. USA 801 489 8611 Valtek CavControl Trim GENERAL INFORMATION The following instructions are designed to assist in assembling, disassembling and troubleshooting Valtek® globe valves equipped with CavControl™ trim. Product users should thoroughly review this bulletin in conjunctio

Flowserve Corporation, Valtek Control Products, Tel. USA 801 489 8611

3. If the pressure-balanced sleeve binds with the plug, carefully lift the sleeve out with the actuator/plug assembly. Place several sturdy, soft supports (pref- erably wood) underneath the sleeve after it clears the body. Lower the actuator/plug assembly until the sleeve and the supp

Flowserve Corporation, Valtek Control Products, Tel. USA 801 489 8611

15-3 4. Retract plug to the full-open position by applying air to the lower cylinder port. 5. Lower the actuator/plug assembly squarely into the valve body. CAUTION: Lower plug squarely into sleeve to prevent galling and scoring of trim parts. Plug seals must be compressed, using an approp

© 2000 Flowserve Corporation. Flowserve Corporation, Valtek Control Products, Tel. USA 801 489 8611

FCD VLAIM015-07 Troubleshooting Chart Failure Probable Cause Corrective Action Jerky stem 1. Overtightened graphite packing 1. Graphite packing is often associated with jerky movement stem movement 2. Galling or scoring between plug 2. Superficial scoring or

Flowserve Control Unit Owners Instructions: