icon Audio LA 4 Instructions
Text of icon Audio LA 4 Instructions
LA 4 Valve Line Amplifier Instructions
About the LA 4
Thank you for purchasing one of our amplifiers, a lot
of care has gone into the design, selection of
components and production of this amplifier. We are
sure that you will hear the difference.
To get the best out of the LA 4. Please read the
enclosed notes. We have tried to give you all the
basic
information
you
will
need.
We would
recommend that everyone follows the ‘quick set
up g
This amplifier has been carefully checked, tested and final adjustments made by Icon Audio in
Leicester.
It has passed our rigorous listening test and final inspection to assure you of optimum
performance and reliability.
Date
…./…./….
Model
……….
Amp Serial Number
……….
Customer
……………………………
Check amplifier finish
……….
Run 6 hour test
……….
Check all inputs & tape monitor
……….
S
QUICK SET UP GUIDE
1 Unpack unit carefully. Make sure that it is in good
condition. It is important that you keep packaging for
warranty/service return.
2 Fit the rectifier valves.
This should be obvious as there are only two types of
socket. The 6SN7s are normally left fitted. Do not
pull the 6SN7s by the glass envelope! This could
cause the glass envelope to become detached from
the base causing irreparable damage.
3 Connect to source & Output u
Check the 1amp mains fuse at the back of the
amplifier. To gain access, remove the mains lead.
The fuse is in a small plastic drawer, which forms part
of the socket assembly. To open insert a flat bade
screwdriver or similar and prise open. The fuse in
use is the innermost the outer is a spare. Should the
replacement fuse also blow there is a fault.
Replacements should be 1Amp ‘anti-surge’.
The fuse in the mains p
When unpacking you may find it
easier to remove the unit if you follow
this procedure:
1. Turn the box “upside down” with
the “flaps” open.
2. Then to lift the cardboard box off.
3. Remove the bottom packing first.
4. Turn the unit the right way up and
remove the top packing.
Please be careful not to damage the
small “tape monitor” switch on the
front panel
If all four feet do not sit level, small adjustments may be
made by adjusting one