Associated Electrics Qualifier Series Manual 

Text of the manual

:: Pro Rally Platform Features

:: Other Helpful Items Associated Electrics, Inc. 26021 Commercentre Dr. Lake Forest, CA 92630 http://www.TeamAssociated.com · http://www.RC10.com · http://twitter.com/Team_Associated · http://bit.ly/AEonFacebook Customer Service Tel: 949.544.7500 Fax: 949.544.7501 Thank you for purchasing

11-13..........Spur Gear / Rear Diff Access

13-14..........Front Diff Access 14.................Diff Maintenance 14-15..........Shock Maintenance 16.................Motor Manual 17................. ESC Manual 18-27..........Catalog 28................1:1 Hardware “Fold Out” 29................Optional Tools / Contact Info 30................Trouble Shooti

:: Blueprint of a Pro Rally

Front CVA Rear Dogbone Turnbuckle (Front Camber Link) Turnbuckle (Front Steering Link) Turnbuckle (Front Servo Link) Nerf Bar Receiver Box Electronic Speed Control Battery Strap Battery w/ Deans® Plug Slipper Clutch Pinion Motor Spur Gear Turnbuckle (Rear Camber Link) Caster Block Drive Shaft Steering Block Rear Hub Front Shock

:: Quick Start Guide

:: Quick Start Guide - (cont.) :: Quick Start Guide - (cont.) Battery Charging Steps and Safety: NiMH Wall Charger: (Part #29154 - Wall Charger AC 120V 350MaH) NiMH Quick Charger: (Part #610 - Reedy 447-S AC/DC 4-7 Cell Peak Prediction NiMH/NiCd Charger) Remove the battery from the vehicle before charging. Be sure to select the correc

:: Quick Start Guide - (cont.)

:: Quick Start Guide - (cont.) Battery Notes and Tip: Plug the battery in as shown. Unplug battery when not in use! There are two types of batteries you can use with this vehicle. NiMH (nickel-metal hydride) and LiPo (lithium polymer). LiPo: LiPo batteries (lithium polymer) are high current rechargeable batteries. LiPo bat

:: Quick Start Guide - (cont.)

Right Left :: Quick Start Guide - (cont.) Radio System Tuning and Controls: RULE: Transmitter on First/Vehicle on Second, Vehicle off First/ Transmitter off Last! 1) Slide the battery cover in the direction shown to remove cover. 2) Install six (6) alkaline or rechargeable AA size batteries into the battery holder.

:: Wiring Diagrams

:: Wiring Diagrams - (cont.) Motor and Receiver Wiring: 1. If motor runs in reverse when you apply throttle, unplug any two of the motor wires and switch them. 2. Your Receiver has multiple channel ports for plugs. Channel 1 - you should always plug your steering servo into this channel port. Channel 2 - you should always plug your speed

To correctly set your gear mesh, follow the steps below:

1. Remove the Chassis Brace. Loosen the set screw on the motor’s pinion gear. Slide the pinion on the motor shaft until the gear face of the pinion is entirely aligned with the gear face of the spur gear (see diagram). Tighten the set screw while ensuring it is aligned with the flat fa

:: Camber / Toe

:: Slipper Adjustments Front Camber Angle: A good starting camber setting is –2 degrees (where the top of the tires lean inwards). Positive camber, where the top of the tire is leaning out, is typically not recommended. Front Toe-In: Zero degree toe-in (tires pointing straight forward) is a good starting setting. You can increase steeri

Other Motorized Toy Car Manuals