Gecko Aeware Swim spa solution Tech Book

table of contents in.xe™ error codes spa pack error codes summary - in.xe™ error codes ....................................................... 27 - Hr or Hr2 error condition ........................................... 30 - HL or HL2 error condition ........................................... 31 - FLO or FL2 error condition .... ...

introduction Swim Spa Solution™ Make your swim spa installation more flexible! The control solution has been designed to be more flexible and support more outputs. The system includes two in.xe™ packs, one in.k600™ keypad with streamlined interface and an in.k100™ auxiliary keypad. An interface cable (8') is provided with the ...

WARNINGS: Before installing or connecting the unit, please read the following. * FOR UNITS FOR USE IN OTHER THAN SINGLE-FAMILY DWELLINGS, A CLEARLY LABELED EMERGENCY SWITCH SHALL BE PROVIDED AS PART OF THE INSTALLATION. THE SWITCH SHALL BE READILY ACCESSIBLE TO THE OCCUPANTS AND SHALL BE INSTALLED AT LEAST 5 FEET (1.52 M) AWAY, ADJACE ...

in.k600 TM dimensions in.k600 TM dimensions: Specifi cations and design are subject to change without notice. General specifi cations: Environmentals: Storage temperature: 85°C (185°F) to -30°C (-22°F) Operating temperature: 65°C (149°F) to -20°C (-4°F) Humidity: up to 95% condensing Mechanical Specs: Weight: 0.4763 Kg (1.05 ...

Specifi cations and design are subject to change without notice. in.k100 TM dimensions General specifi cations: Environmentals: Storage temperature: 70˚C (158˚F) to –30˚C (-22˚F) Operating temperature: 60˚C (140˚F) to –20˚C (-4˚F) Humidity: 100% condensing Mechanical Specs: Weight: 0.41 kg (0.9 lbs) Dimensions (W x H x D) ...

Gasket with or without adhesive To install the in.k600 TM low profile, determine the mounting location and cut out a rectangular shape opening of 7.250" by 3.750" (see illustration). Clean the installation surface and peel the adhesive gasket from the back of the keypad. Insert keypad and align it correctly, then ensure it's properly ...

plumbing Swim spa installation scheme XP2 water jet MASTER in.xe™ spa filter flow spa SLAVE in.xe™ flow flow * Requirers a minimum of 18 GPM About 2' ...

To install the wiring for the in.xe™ spa control, you'll need a Phillips screwdriver and a fl at screwdriver. Loosen the 2 screws of the Spa Pack door and open it. Remove 5 1/2" of cable insulation. Strip away 1" of each wire insulation. Pull the cable through the cut- out of the box and secure it bonding lug with a strain relief (1 ...