Fimer TRIO-20.0-TL-OUTD Quick Installation Manual

In addition to what is explained in this quick installation guide, the safety and installation information provided in the product manual must be read and followed. The technical documentation for the product is available at the website. The device must be used in the manner described in the manual. If this is not the case the safety devices guaranteed by the inverter might be ineffective. ...

The labels on the inverter have the Agency marking, main technical data and identification of the equipment and manufacturer A Inverter model B Inverter part number C Inverter serial number D Week/Year of manufacture E Main technical data Fimer S.p.A. Via Tortona, 25 - I 20144 Milano (MI) B C D Vdc max Vdc Operating Range Vacr fr Iac max Pacr (cos = ± 0.9) φ Pacr (cos = 1) φ MODEL: TRIO-XX.X-TL-OUTD-XXX-400 Made in Italy DIN ...

-Install in safe, easy to reach places -If possible, install at eye-level so that the display and status LEDs can be seen easily -Install at a height that considers the heaviness of the equipment -Install vertically with a maximum inclination of +/- 5° -To carry out maintenance of the hardware and software of the equipment, remove the covers on the front. Check ...

Components available for all models Quantity Connector for connecting the configurable relay 2 Connector for the connection of the communication 4 L-key, TORX TX20 1 Two-hole gasket for M25 signal cable glands and cap 2+2 Two-hole gasket for M20 signal cable glands and cap 1+1 Bracket for wall mounting 1 Components available for all models Quantity Jumpers for configuration of the parallel input channels 2 Quick Installatio ...

All versions of the inverter are equipped with two input channels (therefore with double maximum power point tracker MPPT) independent of each other, which can however be connected in parallel using a single MPPT. - Configuration of parallel-connected channels This configuration involves the use of the two input channels (MPPT) connected in parallel. This means that the jumpers (12) between the two channels (positive and negativ ...

For the connection of the inverter to the grid, you can choose between a star connection (3 phases + neutral) and a delta connection (3 phases). B WARNING – In any case, connection of the inverter to ground is mandatory. To prevent electrocution hazards, all the connection operations must be carried out with the disconnect switch downstream of the inverter (grid side) open and locked. For all models, connection with the AC ou ...

Do not place objects of any kind on the inverter during operation! Do not touch the heatsink while the inverter is operating!Some parts may be very hot and cause burns. The inverter commissioning procedure is as follows: -Turn the AC+DC disconnect switch (14) to the ON position. If there are two separate external disconnect switches (one for DC and the other for AC), first close the AC disconnect switch and then the DC d ...

8 For more information please contact your local FIMER representative or visit: fimer.com We reserve the right to make technical changes or modify the contents of this document without prior notice. With regard to purchase orders, the agreed particulars shall prevail. FIMER does not accept any responsibility whatsoever for potential errors or possible lack of information in this document. We reserve all ...