Creative Playthings Playtime PS10CLASB Assembly Manual

Text of Creative Playthings Playtime PS10CLASB Assembly Manual

MODEL PS10CLASB & PTCLASB

ASSEMBLY MANUAL If you have problems or questions about your Creative Playthings Play Set, DO NOT CALL THE RETAILER. Contact Creative Playthings Customer Service at 1-800-598-4997 or [email protected] Please read the owner’s manual before assem- bling your Play Set, it provides additional information on the care and use of your Play Set. You must carefully read the entire instruction manual before proceeding

© Copyright 2010, Creative Playthings. Printed in U.S.A.

MODEL PS10CLASB & PTCLASB 19771-100 Rev H (05-20) Page 2 PLAY SET SAFETY Observing the following statements & warnings reduces the likelihood of serious or fatal injury: • Children should use equipment only in its intended manner. • Children should not wear loose or stringed clothing while using playground equipment. • Children should not play on equipment in wet weather conditions du
MODEL PS10CLASB & PTCLASB 19771-100 Rev H (05-20) © Copyright 2010, Creative Playthings. Printed in U.S.A. Page 3 SAFE PLAY AREA SELECTING THE CORRECT LOCATION FOR YOUR PLAY PRODUCT IS IMPORTANT FOR YOUR CHILDREN’S SAFETY AND THE PRODUCT’S LONGEVITY. Play Set Dimensions: • The MODELS PS10CLASB and PTCLASB Swing Sets have ground dimensions of 9'-0" x 10'-0". • The Swing Set requires a level ground surface of 21'-0" x 28'-3' for a Safe Pl
© Copyright 2010, Creative Playthings. Printed in U.S.A. MODEL PS10CLASB & PTCLASB 19771-100 Rev H (05-20) Page 4 COMPONENTS A B H D F G C J I 60057-101 Playtime Classic Swing Beam A 2 32797-102 Swing Beam Leg Brace 2 x 4 x 71" B 4 33123-102 Swing Beam Leg 4 x 4 x 102-3/8" C 1 40517-102 Classic Beam Assembly 50465-100 Accessories, Playtime Classic Swing Beam D 4 14022-101 Safe-T-Connect Bracket, Right E 4 14022-201 Safe-T-Connect Bracket, Left F
MODEL PS10CLASB & PTCLASB 19771-100 Rev H (05-20) © Copyright 2010, Creative Playthings. Printed in U.S.A. Page 5 MAINTENANCE INSTRUCTIONS Re-staining Information: (Your Play Set is stained at our factory. No stain is needed at initial assembly.) • Pigmented, exterior, water repellent stains are recommended and will provide an excellent barrier against moisture without hiding the natural wood grain or leaving a film that may later crack or peel
© Copyright 2010, Creative Playthings. Printed in U.S.A. MODEL PS10CLASB & PTCLASB 19771-100 Rev H (05-20) Page 6 ASSEMBLY INSTRUCTIONS STEP 1 – Secure Beam Assembly: Lay out the Swing Beam in the play area. The holes for the swing connectors should face upward. Secure the two rails of the Beam Assembly (C) using eight 1/4" x 3" Hex bolts, 1/4" Lock Washers, 1/4" Flat Washers and 1/4" Weld Nuts, as shown. ASSEMBLY INSTRUCTIONS STEP 3 – Safe-T

Creative Playthings Play Sets & Playground Equipment Owners Instructions: