Creative Playthings CH947-403 Assembly Manual

Text of Creative Playthings CH947-403 Assembly Manual

CH947-403 & SH947-102

ASSembly mAnuAl Rope lAddeR illustration #1 Wooden pARtS Please review your original Playset Assembly Manual and your Owners Manual before assembly of your Rope Ladder. All hardware on this set is specially coated for corrosion resistance. If non-Creative play- things hardware is used, it muSt be galvanized or stainless steel. toolS RequIRed HARdWARe Wood Screw Hex Bolt Weld Nut Lock Washer Flat Washer Lag Screw Hole Cap illustration

© Copyright 2005, Creative Playthings, printed in U.S.A.

ROPE LADDER 19695-300 Rev B (07-16) page 2 Step 1 - top Rope ladder beam Rest the Top Rope Ladder Beam Assembly (F) on the Gym Wall Support in the position desired. The longer board in the Beam Assembly should be directly above the Wall Support. Align the holes in the middle of the Beam Assembly (F) on the center of the adjacent Gym Corner Post. Mark the position of the holes w

19695-300 Rev B (07-16)

© Copyright 2005, Creative Playthings, printed in U.S.A. page 3 ASSembly InStRuCtIonS 2" Step 3b - bottom Support (Alternative 2) Remove the Access Ladder from the Gym. Save the hardware; the Access Ladder will be re-attached. Lay the Access Ladder face down. Drill a 1/4" diameter pilot hole 1-1/2" deep in the center of each Access Ladder Rail, 3-1/2" from the bottom. Fasten the Bottom Rope Ladder Support (B) to the Acc

Save all instruction sheets and receipts in case it becomes necessary to

contact Creative playthings for warranty service and/or part replacement. the warranty can be found in your owner’s manual. please fill out the warranty card on the back of your owners manual. your completed warranty card will allow us to quickly process warranty claims. thank you. © Copyright 2005, Creative Playthings, printed in U.S.A. ROPE LADDER 19695-300 Rev B (07-16) 50353-

Creative Playthings Play Sets & Playground Equipment Owners Instructions: