Creality Ender-5 Plus Manual Book

◆ Please plug the power cord into a three-hole power jack. ◆ Detailed instructions are available in the TF card. To be the Chief Evangelist To make Top-quality 3D printer Ender-5 Plus Printer Guide Book ...

damage. 2. Do not place the printer near any heat source or flammable or explosive objects. We suggest placing it in a well-ventilated, low-dust environment. 3. Please place your printer under a stable environment in order to achieve hight prin ...

1.Introduction....................................1 2.General List....................................2 3.Assembly Step.......................................3 4.Cable Connection............................7 5.Screen Information........................8 6.Loading Filament...........................9 7.Bed Leveling.....................................10 8.Sof ...

3. Hot Bed 4. Main control box 5. Power switch 6. Touch screen 7. Leveling nut 8. Hot end 9. X-axis limit switch 10. X-axis motor 11. TF card＆ USB 12. Z-axis motor 13. Antivibration feet 14. Filament Holder 15. Y-axis motor 16. Y-axis limit switch Introduction ： 1 ...

Tool List G:Bottom Frame F:Z-axis Frame D:2040 Aluminum profile(4Pcs) E:Hot Bed C:Filament Holder A:Top Frame B:Extruder kit No. Image Name Qty 1 Wrench & Screw driver 1set 2 TF Card & Reader 1set 3 Spatula 1 4 Pliers 1 5 0.4mm Nozzle Cleaner 1 6 Power Cable 1 7 Filament(200)g 1 8 Spare Parts 1set 9 USB 1 2 ...

Step 1. Keep the front of the Bottom Frame facing you. Step 2. Take one of the Aluminum frame pieces and place it in the corner of the bottom frame , On top of the frame, and lined up with the corner. Notice the hole at the top of piece facing left and righ ...

the top, then tight the side screws. 2. Facing your top-side Y-axis passive block, you can adjust it to adjust the timing belt tightness. Front Frame Assembly Pt. 2 8pcs M5X25 Ready: Top Frame Step 1. Make sure the front of the bottom frame is facing you . Step 2. 1) Place the Top frame on top of all four al ...

Right Z-axis Frame Ready: Frame Assembly Pt. 3 Step 1. Make sure the front of the bottom frame is facing you . Step 2. Place double Z-axis frame inside of previously assembled frame. The double Z-axis frame is mounted on the left and right 2040 aluminum profiles of the top frame and must be aligned w ...

Hot Bed Filament Holder 8pcs M4X10 M5X8 2pcs M5 T-nut Step 1. Make sure the front of the base(b) is facing you. Place the hot bed on the support plate of the double Z-axis frame and align with the profile holes on it. Step 2. Using 4 M4x10 screws, connect the hot bed to the support plate on the Z-axis frame. Make sur ...

match your local mains (230V or 115V). Bed Cable Connection Nozzle Cable Connection 7 Cable Connection ： BL Touch Connection Broken filament detecting device Connection 5Pin 3Pin ...