Everfit POWER SMART Instruction
Text of Everfit POWER SMART Instruction
Attach the FRONT STABILIZER(3) to the CENTER BEAM(2) with CARRIAGE BOLTS(M8x1.25x40mm)
(23), WASHERS(M8)(12), and ACORN NUTS(M8x1.25)(14).
STEP 2
Refer to the illustration below and detail view A. Attach the SEAT(7) to the SEAT CARRIAGE(5) with BUTTON
HEAD BOLTS(M8x1.25x15mm)(21) and WASHERS(M8)(12). Slide the twoSECURING ROLLERS(33)
to the shafts on the SEAT CARRIAGE(5). Slide the SEAT CARRIAGE ASSEMBLY(5) onto the CENTER
BEA
Insert the STOPPER SHAFT(30) through the hole in the CENTER BEAM(2). Screw two STOPPERS(29)
onto both ends of the STOPPER SHAFT(30) and tighten at the same time.
STEP 4
Attach the REAR SUPPORT(1) to the CENTER BEAM(2) with BUTTON HEAD BOLTS(M8x1.25x15mm)
(21) and WASHERS(M8)(12). Press The OVAL CAP(31) into the back end of the CENTER BEAM(2).
STEP 5
Attach the SHOCK(10) to the bracket at the front of theCENTER BEAM(2) with BUTTON HEAD BOLT
(M8x1.25x
Attach the ROWING ARM(43) to the CENTER BEAM(2) with BUTTON HEAD BOLT(M10x1.5x80mm)(26),
WASHERS(M10)(27), and NYLOCK NUT(M10x1.5)(28). Connect the SHOCK(10) to one of the adjustment
holes on theR OWING ARM(43) and secure with theLOCKING KNOB(44) and theADJUSTMENT
KNOB(45). Refer to the detail view below. The shoulder of the LOCKING KNOB(44) and end of the
ADJUSTMENT KNOB(45) must be inserted into one of the adjustment holes
Insert the PEDAL SHAFT(19) through holes located on the
CENTER BEAM(2). lide a PEDAL SPACER(20)
and a PEDAL CAP(18) onto each end of thePEDAL SHAFT(19). Then secure thePEDAL CAPS(18)
with BUTTON HEAD BOLTS(M8x1.25x15mm)(21) and LARGE WASHERS(M8)(22) at both ends of the
PEDAL SHAFT(19).
NOTE: You need to use two Allen Wrenches to tighten the BUTTON HEAD BOLTS(M8x1.25x15mm)(21)
at both ends of the PEDAL SHAFT(19) at the same t
USING THE FITNESS METER
POWER
ON :
POWER OFF :
Handlebar movement
Automatic shut off after four minutes of inactivity.
STROKES
/MIN
SCANN
CNT
TIME
CAL
FUNCTION BUTTONS:
MODE : Press to select the function of the lower readout.
RESET : To reset all functions to zero.
M
R
FUNCTIONS:
COUNT :
SCAN:
TIME:
STROKES/MIN:
CALORIE:
NOTE: 1.
2.
Upper readout displays the total number of strokes you have taken from zero to 9999
strokes.
Automatical
Via Regione Piemonte, 32 - Zona Industriale D1
15068 - Pozzolo Formigaro (AL) - Italy
www.everfit.it - [email protected]