AMP MAKER N5X Construction Manual
Text of AMP MAKER N5X Construction Manual
This build guide describes how to build the
N5X guitar amplifier kit from Amp Maker.
The N5X is the successor to the very
popular SE-5a 'British Overdrive' amplifier
kit. The circuit is almost identical, but
with some of the most popular
modifications added as standard:
1.
VCB for getting power valve
distortion at lower room volumes
2.
Switchable boost: None/Bright/Fat
3.
Bypassable tone stack for more gain
4.
More power valve options:
E
N5X Construction guide
2
N5X Construction guide
Kit contents
Your N5X amplifier kit contains all of the electronics and hardware parts needed to make a great-
sounding valve amplifier. Before jumping in, clear a space on your workbench and unpack all of the
components. Start by checking the Kit contents listing below. Look through the electronic components
R1
1M/0.5W
R2
15k/0.5W
R3
1.5k/0.5W
R4
100k/0.5W
R5
47k/0.5W
R6
47k/0.5W
R7
470k/0.5W
R8
15k/0.5W
R
and check them off. If this is your first amplifier project take a little time to familiarise yourself each type
of component, its shape, size and connections (leads, solder lugs, etc).
Resistors
The Kit contents page lists the resistors first. Most resistors are too small to have printed values, and
instead the manufacturers use a standard set of colour coded bands to indicate the resistor's value. You
can decipher th
N5X Construction guide Capacitors
Almost all modern capacitors have their values and ratings printed somewhere on their body. This
written information makes it easy to work out which capacitor is which. (There is a colour coding system
for certain types of small capacitor but none of those are included in this project.)
The first part of the text is the capacitance value itself. This is shown in units of microFarads (uF),
nanoFarads (nF) or picoFarad (pF
Some capacitors have a polarity - a positive terminal and a negative terminal. In this amplifier kit,
the blue/black electrolytic capacitors are all polarised. Look closely at the printing and you will see that
one of the leads on each of these capacitors is marked by a minus sign (-). This is often contained within
an arrow printed on the side of the capacitor, where the direction shows the negative terminal.
Potentiometers
Variable res
N5X Construction guide Look closely and you will see that the diodes all have a small band around one end: silver on the
black diodes and black on the pink zener diode. This shows the polarity of the diode - the banded end is
the cathode. To do its job properly and safely, a diode MUST be fitted the correct way around as shown in
the build guide diagrams that follow.
WARNING! The MOSFET needs special handling, so do not take it out of its anti-static bag
The rest of the kit contents list spells out the sockets, switches, etc you use to make up the rest of the
circuit. Check the contents against the list and let Amp Maker know of any problems or missing parts.
Wire and Hardware
There's also a bag of wire with several types and colours of wire: solid, stranded, insulated, bare and
shielded. Don't worry, there's more than enough cable to build the amplifier. In addition, a
N5X Construction guide N5X schematic
The page opposite shows the N5X's full-size schematic. This diagram shows all of the component values
added and with numbered lugs for all off-board components. All components are numbered on the
schematic (R1, C3, D4, etc), so that you can relate this schematic to your Kit contents listing and the
turret board layouts.
Do I need to be able to read a schematic?
This is a very common question for new amp builders who m