Draytek Vigor167 Quick Start Manual

Version: 1.0 Firmware Version: V5.0 (For future update, please visit DrayTek web site) Date: June 23, 2021 ...

Copyrights © All rights reserved. This publication contains information that is protected by copyright. No part may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language without written permission from the copyright holders. Trademarks The following trademark ...

We DrayTek Corp. , office at No.26, Fu Shing Road, HuKou County, Hsin-Chu Industry Park, Hsinchu 300, Taiwan , R.O.C., declare under our sole responsibility that the product  Product name: 35b Modem  Model number: Vigor167  Manufacturer: DrayTek Corp.  Address: No.26, Fu Shing Rd, HuKou, HsinChu Industrial Pa ...

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if no ...

1. Package Content .................................................................................................. 1 2. Panel Explanation................................................................................................. 2 3. Hardware Installation ......................................................... ...

Coonntteenntt Take a look at the package content. If there is anything missed or damaged, please contact DrayTek or dealer immediately. Modem Quick Start Guide RJ-11 to RJ-45 Cable RJ-11 to RJ-11 Cable The type of the power adapter depends on the country that the modem will be installed. * The maximum power consumption is 4.5 Watt. ...

LED Status Explanation Off The system is not ready or is failed. ACT Blinking The system is ready and can work normally. On A normal connection is through its corresponding port. Off LAN is disconnected. P1/P2 Blinking Data is transmitting (sending/receiving). On xDSL connection synchronized. DSL Blinking xDSL conne ...

and configure the modem’s settings through web browser. Before starting to configure the modem, you have to connect your devices correctly. 33..11 N Neettw woorrkk C Coonnnneeccttiioonn 1. Connect the DSL interface to the MODE ...

1. Drill the holes on the wall according to the recommended instruction. 2. Fit screws into the wall using the appropriate type of wall plug. Note The recommended drill diameter shall be 6.5mm (1/4”). 3. When you finished about procedur ...