Ambient UMP III Instruction Manual

© 2020, Ambient Recording GmbH Universal Microphone Power Supply Instruction Manual ...

© 2020, Ambient Recording GmbH Preparing the UMP III - Push the battery lever on the bottom in and slide right (direction MIC connector) - Insert battery with the polarity protection gap to the left when looking at the front - Close the door and push back to the left Power on Plug in the Mic In cable. The device can only be switched on with the Mic In cable connected. Press the button until the LED turns from red to green, release. The LED will now display the current power setting. ...

© 2020, Ambient Recording GmbH Power settings LED color: • Blue (default): 48V Phantom • White: 12V Phantom • Yellow: 12V T-Power • Red: Low battery, approx. 15min operation left Note: Default setting is 48V phantom, but the unit will retain a previously selected mode. To prevent damage caused by improper power mode, check the current active setting matches your microphone before connecting it. Check the setting while unit is on briefly tap the button. The Led will blink in the color of the active setting. Changing the power sett ...

© 2020, Ambient Recording GmbH Power off Press the button until the LED lights up red and briefly blinks, release. Alternatively, simply detach the mic input cable at the unit. You can control by tapping the button. Connectors MIC (input): • Pin 1: GND • Pin 2: Signal hot (12V on T-Power) • Pin 3: Signal cold • Pin 4: Battery negative (must be bridged to pin 1) TX (output): • Pin 1: GND • Pin 2: Signal hot • Pin 3: Signal cold Technical Details • Dimensions (WHD): 44 mm x 66 mm x 20 mm • Weight (incl. battery): 100 g � ...