CommScope SYSTIMAX M10MMFP Instruction Sheet

Instruction Sheet 848380986 Issue 6, June 2013 SYSTIMAX M10MMFP Multimedia Faceplate Instructions © 2013 CommScope, Inc. All rights reserved Page 1 of 11 General The SYSTIMAX M10MMFP multimedia faceplate brings copper and fiber to a common faceplate, in an existing or new installation. It work ...

How to Contact Us • To find out more about CommScope® products, visit us on the web at http://www.commscope.com/ • For technical assistance: - Within the United States, contact your local account representative or technical support at 1-800-344-0223. Outside the United States, contact your loca ...

Page 3 of 11 Separately Orderable Parts Material ID Part No. Quantity Description Used With 108547282 - 25 Labels, in poly bag M10MMFP 107118903 C6061A-4 1 Coupling, SC, mm, duplex, Beige, metal sleeve SC adapter plate 107087967 C6070A-4 1 Coupling, SC/ST Hybrid, mm, duplex, Beige, metal sleeve SC adapter plate ...

Base Features The base attaches to a wall outlet box or to a flat surface using the alternate mounting holes. It provides slack storage for the fiber, four cable attachment points for rear entrance cables, two cable attachment points for side entrance cable, mounting rails for the coupling adapter pl ...

Page 5 of 11 New Installation Step 1 – Install Base (Copper and Fiber Installation) For Fiber Cable 1. Insert fiber cable(s) through opening in base, ensuring at least 3 feet (0.9m) of fiber cable extends through base. 2. Attach base to outlet box or framing using two 1-1/4 inch truss-head screws (provided). F ...

Step 2a – Fiber Cable Installation 1. Anchor fiber cable to one of the tie-down points around the perimeter of the base opening, using a small cable tie (provided). Ensure that the jacket extends 1/4- to 1/2-inch (6 to 13mm) beyond the cable tie to protect the buffered fibers from sharp bends. 3. S ...

Page 7 of 11 Step 2b – Copper Cable Installation 1. Strip the copper cordage per local practices for attachment to modular outlets and terminate to the modular jacks. 2. Feed the terminated cordage and jacks through the back of the faceplate base and snap the individual modules into the faceplate. 3. Attach th ...

Step 2 – Install Faceplate Base and Route New Fiber Cables 1. Strip 3 feet (1 meter) of jacket from the fiber cable. 2. Attach fiber cable to base using a cable tie at one of the cable tie down points around the inside of the slack drum. The jacket should extend 1/4-to 1/2-inch (6 to 13mm) past the ...

Page 9 of 11 6. Fit hooks on bottom of faceplate base into catches on base. Ensure that the slack fibers are clear of the faceplate base catches and latch before engaging. Pivot faceplate base up and press the top of the faceplate base in until the latch at the top engages with the base engage. Above figure show ...

Step 3 – Secure Faceplate and Install Cover 1. Attach the faceplate to the faceplate base using two 1/2-inch Phillips Pan-Head PT screws (provided). 2. Attach the cover to the base by engaging the hooks located at the inside top of the cover with the slots located at the top of the base. The cover ...