Clemco ZERO Pulsar III-P Manual 

PRODUCTS AND THIS INFORMATIONAL MATERIAL Clemco proudly provides products for the abrasive blast industry and is confident that industry professionals will use their knowledge and expertise for the safe and efficient use of these products. The products described in this material and the information relating to these prod ...

Page 1 © 2019 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 21527, Rev. I, 02/19 1.0 INTRODUCTION 1.1 Scope of Manual 1.1.1 These instructions cover the setup, operation, maintenance, troubleshooting, and replacement parts for the following Pulsar® Pressure Blast Cabinets:  ...

Page 2 © 2019 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 21527, Rev. I, 02/19 Door Interlocks ........................................................... 5.4 Pulse Pressure .......................................................... 5.5 Cabinet Air-Inlet Damper ........... ...

Page 3 © 2019 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 21527, Rev. I, 02/19 1.4.3 Power module: The 600 cfm power module is approximate 50" wide x 32" deep. The module is attached to the back of the cabinet and includes a 600 cfm reverse-pulse dust collector, and a 600 cfm ...

Page 4 © 2019 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 21527, Rev. I, 02/19 separation. Dust and fines are first separated from reusable media and pass into the dust collector. Next, reusable media is screened for oversize particles and returned to the reclaimer for reuse. ...

Page 5 © 2019 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 21527, Rev. I, 02/19 1.9 Metering Valve Options 1.9.1 Unless specified at the time of purchase, cabinets are supplied with a fine-mesh Sentinel Metering Valve. The valve is for use with 50-mesh and finer media, and #10 ...

Page 6 © 2019 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 21527, Rev. I, 02/19 This table offers a guideline to media selection based on standard 3/16" orifice nozzle and average conditions, such as air pressure, media-air mixture, visibility, contamination of parts being bla ...

Page 7 © 2019 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 21527, Rev. I, 02/19 2.2 Connect Compressed-Air Supply Line WARNING Failure to observe the following before connecting the equipment to the compressed- air source can cause serious injury or death from the sudden rele ...

Page 8 © 2019 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 21527, Rev. I, 02/19 Figure 5 WARNING Do not use electrical adaptors that eliminate the ground prong on 120-volt plugs. Doing so can cause electric shock and equipment damage. 2.4.2 Optional three-phase wiring All wir ...

Page 9 © 2019 CLEMCO INDUSTRIES CORP.  www.clemcoindustries.com  Manual No. 21527, Rev. I, 02/19 2.6.2 Position the foot pedal on the floor at the front of the cabinet or on the foot shelf on ergonomic models. 2.6.3 A package of five cover lenses is supplied with the cabinet. To install a cove ...