Digi Connect Series Application Manual

How to Create a VPN between Digi and D-Link ________________________________________________________________________ 5/11/2009 Digi International 1 of 6 Scenario Digi Connect family VPN router (for example ConnectPort WAN or Digi Connect WAN IA) is used for remote site connectivity. The primate site is using a D-Link ...

5/11/2009 Digi International 2 of 6 Digi Connect Router Configuration 1. Read and follow the quick-start guide for the Digi Connect router and optionally for Digi Connectware® Manager if used. 2. Assign a static IP address to the Ethernet port (the default address is 192.168.1.1). Note the default gat ...

5/11/2009 Digi International 3 of 6 iv. Click Apply after filling in the above information to complete the tunnel setup on the Digi Connect router. D-Link VPN Configuration 1. Configure the D-Link VPN device a. Log into the Web Interface of the D-Link device. b. Navigate to Firewall > VPN. c. Click Add ...

5/11/2009 Digi International 4 of 6 e. Click Apply to save the changes. f. Click Edit on the newly created item on the VPN page under the IPsec Tunnels heading. g. Click Advanced to configure additional parameters, as shown in the following screenshots: ...

5/11/2009 Digi International 5 of 6 h. Click Apply to save the changes. i. Click Activate on the left hand side to commit the changes that were done to the running configuration of the device. ...

5/11/2009 Digi International 6 of 6 ADDITIONAL NOTES 1. This configuration will work with Dynamic IP addresses, using hostnames established with DynDNS.org, or using the DDNS update feature of Digi Connectware® Manager. When using a Dynamic IP address, you will need to set the VPN tunnel to use Aggre ...