Clarke CWB1630R Assembly Instructions
Text of the manual
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
INTRODUCTION
Thank you for purchasing this CLARKE product. Before assembling the
workbench, be sure to read these instructions thoroughly. In doing so you will
ensure the safety of yourself and of others around you, and you can look
forward to the product
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
ASSEMBLY
The tabs of the beams will often enter the slots fully using just firm hand
pressure but if they are too tight, you may require a rubber mallet or hammer
to assist. If so, always use a cloth to
protect the product paint finish.
1. Decide how high
7. Fix the shelf clips to the centre
support and place the small
board on the half shelf
8. Fit the plastic post caps top of each
post as shown in Fig 5.
SAFETY ADVICE
•
Always place heavier items on the
shelf where possible.
•
Always distribute your loads evenly
where possible.
GUARANTEE
Parts & Service: 0208 988 7400
E-ma