ELTEX R130A Manual 

3 List of Contents 1 Overview charging bars. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 1.1 R130A / R131A / EXR130A charging bars. . . . . . . . . . . . . . . . . . . . 6 1.2 R130A3L / EXR130A3L charging bars. . . . . . . . . . . . . . . . . . . . . . . 7 2 Safety. . . . . . ...

5 Dear customer The R130A / R130A3L / R131A / EXR130A / EXR130A3L charging bar is a universal bar for charging surfaces for the purpose of tacking, adhering or locking. The variable active lengths of the charging bars allow them to be adapted to your specific in-process conditions and requirements ...

1. Overview charging bars The variety of charging bars available differs essentially in their installation lengths and in their connection of the high voltage cable. Both the installa- tion length and the variable active length of a charging bar allow the units to be adapted to the most varied a ...

7 R130A / EXR130A bar The connection of the high voltage cable can be axial or at a right angle to the bar. R131A bar The connection of the high voltage cable is detachable and only available axial to the bar. 1.2 R130A3L / EXR130A3L charging bars R130A3L / EXR130A3L bar Same bar as R130A / EXR130 ...

2. Safety The units have been designed, built and tested using state-of-the-art engi- neering, and have left the factory in a technically and operationally safe condition. If used improperly, the units may nevertheless be hazardous to personnel and may cause injury or damage. Read the operating ...

9 2.3 Work and operational safety Warning! Electric shock hazard! Carefully observe the following notes and the complete chapter 2 "Safety”, page 8! • Before carrying out repairs, cleaning or maintenance work and before resetting the unit after malfunctions, switch off the power supply and dis ...

kept clean (see chapter 3.6 "Connecting the high voltage cable of the charging bar to the high voltage generator POWER CHARGER PC_ _”, page 18). • The operating voltages of the charging bars are different. Make sure that the correct distance between the charging bar and the material sur- fa ...