FCI AIRMAX Manual 

Text of the manual

FCI USA LLC

Manual Part No. 10118041-9090 Issued: (2011/08/12) Page 1 of 9 Revision A AIRMAX STITCHED HEADER REMOVAL TOOLING Figure 1 For Use With Removal Of 3x6, 4x16, 4x10, 5x10 Stitched Vertical Headers FCI MANUAL P/N 10118041-9090 PDS: Rev :A STATUS:Released Printed: Oct 13, 2011 Downloaded from Arrow.com.

FCI USA LLC

Manual Part No. 10118041-9090 Issued: (2011/08/12) Page 2 of 9 Revision A Table of Contents INTRODUCTION..................................................................................................................................................................3 General Description ............................................................

FCI USA LLC

Manual Part No. 10118041-9090 Issued: (2011/08/12) Page 3 of 9 Revision A Introduction General Description This instruction manual covers the use and maintenance of the line of Airmax Stitched Header Removal Tools The “Airmax Stitched Header Removal Tool” (AHR) is designed to plug into the header, much as you would a mating receptacle connect

FCI USA LLC

Manual Part No. 10118041-9090 Issued: (2011/08/12) Page 4 of 9 Revision A Safety General Safety Rules 1. Keep Observers Away: All visitors should be kept safe distance from work area. 2. Don’t Force The Tool: It will do the job better and safer at the rate for which it was designed. 3. Use The Correct Tool: Don't force a tool to do a job fo

FCI USA LLC

Manual Part No. 10118041-9090 Issued: (2011/08/12) Page 5 of 9 Revision A REMOVAL PROCEEDURE 1. Verify that there is sufficient “keep-out” zone provided on either side of the board-mounted module sidewalls for the outer standoffs of the Jack-Frame. • A keep-out zone is an area on the backplane, to either side of a connector that was designe

FCI USA LLC

Manual Part No. 10118041-9090 Issued: (2011/08/12) Page 6 of 9 Revision A Figure 3 Removal Tool Inserted Into Connector (Pressure Rod Raised & Jack-Frame Seated On PCB) 4. Verify that the Plate Guide is at least partially inserted into the header and allow the Jack- Frame to rest on the backplane. At this point, the tool is positioned and is now

FCI USA LLC

Manual Part No. 10118041-9090 Issued: (2011/08/12) Page 7 of 9 Revision A 6. While continuing to apply downward force to the Pressure Rod, begin turning the Knob in a clockwise direction to start lifting the connector off the board. • Once the connector is free of the backplane, it is not necessary to continue to turn the knob and you can proce

FCI USA LLC

Manual Part No. 10118041-9090 Issued: (2011/08/12) Page 8 of 9 Revision A MAINTENANCE It is recommended that each operator of the tool be made aware of, and responsible for, the following maintenance steps: 1. It is good practice to keep the hand tool clear of extracted pins. 2. Remove dust, moisture, and other contaminants with a clean brush, or

FCI USA LLC

Manual Part No. 10118041-9090 Issued: (2011/08/12) Page 9 of 9 Revision A PDS: Rev :A STATUS:Released Printed: Oct 13, 2011 Downloaded from Arrow.com. Downloaded from Arrow.com. Downloaded from Arrow.com. Downloaded from Arrow.com. Downloaded from Arrow.com. Downloaded from Arrow.com. Downloaded from Arrow.com. Downloaded from Arrow.com. Downloa

More FCI Tools Owners Instructions: