Burkert 8640 Quick Start Manual

Technische Änderungen vorbehalten. Sous réserve de modifications techniques. © Bürkert Werke GmbH & Co. KG, 2009 - 2019 Operating Instructions 1901/11_EU-ML_00804431 / Original DE ...

1.1 Definition of the Term “Device” .....................................................4 1.2 Symbols ..............................................................................................4 2 inTended use ........................... ...

regarding the use of the device. A detailed description can be found in the operating instructions for Type 8640. Keep the Quickstart in an easily accessible location for each user. The Quickstart must be available to each new owner of the device. important s ...

people, nearby equipment and the environment. ▶ The device may be used for the control of pneumatically oper- ated units. ▶ Do not use the device outdoors unprotected. ▶ Do not physically stress the housing (e.g. by placing objects on it or standing on it). ▶ ...

The device contains electronic components, which react sensitively to electrostatic discharge (ESD). Contact with electrostatically charged persons or objects is hazardous to these components. In the worst case scenario, they will be destroyed immediately or will fail after st ...

according to the EC Declaration of Conformity. 6.2 standards The applied standards, which verify conformity with the EC Direc- tives, can be found on the EC-Type Examination Certificate and / or the EC Declaration of Conformity. 6.3 General Technic ...

Type 6524 3/R X* 2/A 1/P Type 6525 X* 5/R 4/A 1/P 2/B 3/S Design the pressure supply with the largest possible volume! X* - pilot control Fig. 2: Fluid connection. Types 6524 and 6525 6.3.3 fluid and electrical connection Hand lever assignment Type 6524 (2 x 2/3-way valve) 12 14 - Pin coil 12 controlled via bit “n+1” - ...

If the seals are not seated correctly, leaks and malfunctions may occur due to pressure losses. ▶ Ensure that the seals are seated correctly in the area of the elec- tronics and pneumatics. short-circuit, malfunction! The electrical connection requires exact contacting. ▶ Do not bend contacts. ▶ If ...

→ Establish a short, wide PE connection between the standard rail and the control cabinet. The valve terminal must be freely accessible from above. Ensure good heat dissipation! recommended distance when installing in a control cabinet: a 30 mm c 30 mm b 30 mm d 60 mm 7.2.2 installatio ...