G.Q.F. 1200E Series Instructions
Text of the manual
READ THE FOLLOWING BEFORE STARTING
The location of the incubator is important to successful operation. A thermostatically controlled room temperature between 75 F to 80 F (24 C
to 27 C) degrees with fresh air without drafts is ideal. Room temperatures from 55 F to 90 F (13 C to 32 C) are acceptable but good temperature
control in the incubator is obtained
Humidity readings are adjusted in the incubator primarily by adjusting the surface area of water exposed to the air. Levels of humidity can be
increased by adding one or two wick pads to the pan. If higher levels are required then a room humidifier may be needed in the incubator room.
For setting of most eggs the moisture pan with water in it will be suffi
Start checking the eggs that are due to hatch
a full day before expected hatch day. Look for
any signs of piping or hatched eggs and note
this on the calendar for that day. After the hatch is complete check the un-
hatched eggs for any development such as blood rings, partial or fully formed
chicks to establish the number or percentage of fertile eggs that
Humidity wick pads (2)
12
No 3179
Off/On switch with fuse
2
No 4500
Humidity pan
13
No 3178
Fuse 250-V 5amp fast blow
3
No 3170
Heater assembly 110V
14
No 3248
Analog Electronic Thermostat
4
No 3043
Front support bar
15
No 3170
Heater/Fan Assembly
5