Decware ZKIT-1 Instructions Manual

Text of Decware ZKIT-1 Instructions Manual

ZKIT-1 Single-Ended Triode Amplifier

Instructions Model: SE84DIY March 3, 2019 Website support can be found at: www.decware.com DECWARE / HIGH FIDELITY ENGINEERING CO.

MOUNTING THE CIRCUIT BOARD

Objective The circuit board has been designed to be used in 2 ways; A) Mounted on stand-offs to a piece of wood and B) Mounted on stand-offs inside a metal chassis. The see-thru picture below lets you see the traces on both sides of the board at the same time. DECWARE / HIGH FIDELITY ENGINEERING CO.

The silk screen is printed on the bottom side of the board. The tube sockets mount to the top

side of the board only. Parts can placed on either side of the board depending on how the board is mounted: A) Mounted inside a steel chassis parts (not tube sockets or volume control) are mounted on the bottom side with the silk screened parts layout. B) Mounted on a piece of wood, the parts including tube sockets and volume control are mounted on the top side wh

If you build this amp on a piece of wood make sure you strain relief the power cord by

connecting it to the wood in some fashion. Do not rely on the transformer itself to hold the weight and constant tugging of a power cord. The output transformers as part of their design have very fragile lead terminations. This means bending the wire excessively, or putting anything other than tiny amounts of pulling forces on it will result in the lead wire

Start by using the circuit board as a template to mark the wood or chassis for mounting.

Install the parts in the circuit board and solder them using a low residue solder such as Kester # 245 or similar. If you can’t find a low residue solder then clean the board with alcohol when your finished soldering in the parts. Note: Be sure to install short jumpers in the 6 locations marked J1 through J6. These can be put on either side of the bo

RESISTOR COLOR CODES

To determine the value of a particular resistor you can use the color bands on the resistor and then confirm the computed value with your resistance meter. Use the first two bands to equal the first two digits in the value and then multiply that value by the third band and you will have the ohms of that resistor.

Decware Amplifier Owners Instructions: