CEBEK TL-26 Quick Start Manual

Receptor R.F. 1 Channel TL-26 Voltage. ......................................................12 V. D.C. Minimum/Maximum Consumption. .............2 mA /65 mA. Security Code combinations. .....................13.122. Operating Frequency. ................................433,92 MHz. Antenna Length. ........................................170 mm. Max. Output Load by relay. ........................3 A. Protection against inversion of polarity. ......Yes. Sizes. ........................................................ 98,75 x 96 x 30 mm. TECHNICAL CHARACTERISTICS The remote receiver decodes the signals sent by the emitters Cebe ...

TL-26 ABOUT THE OUTPUT : during circuit operation, and according to its load, may cause a fluctuation or an incorrect operation of the output. If this happens, install an anti-spark circuit (capacitor and resistor 100nF/400 47ohms V. W. ½), between the two relay contacts used in the connection. SUR LA SORTIE: pendant le fonctionnement du circuit, et selon sa charge, peut entraîner une fluctuation ou un fonctionnement incorrect de la sortie. Si c'est le cas, installez un circuit anti-étincelle (condensateur et la résistance 100nF/400 47ohms V. W. ½), entre les deux contacts du relais utilisés pour la connexion. ...

The receiver lets you set the output for a monostable or bistable operation . In monostable mode , when you press the button on the transmitter , the output will be connected , staying connected only while the button is pressed, when released , the output is disconnected. In bistable mode , when you press the transmitter button , the output will activate , staying back on until you press the same button , at which the output is disconnected. Remember that the issuer does not allow the execution of more than one button simultaneo ...

TL-26 GENERAL WIRING MAP. Switch Outpunt 1 Fuse 1A FE-103 Configuration monostable / bistable Dip Outpunt 1 Relay Aux output Antenna TL-26 Security code Alimentation ...