EK-Quantum Vector Strix RTX 3070 Backplate Operation & User’s Manual

Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to chang ...

TABLE OF CONTENTS BOX CONTENTS 4 BACKPLATE DIMENSIONS 5 INSTALLING THE BACKPLATE 6 PREPARING YOUR GRAPHIC CARD 6 CUTTING AND PLACING THERMAL PADS 6 ATTACHING THE BACKPLATE 8 IMPORTANT DISCLOSURES 8 IMPORTANT NOTICE 8 WARRANTY 9 REQUIRED TOOLS 9 SUPPORT AND SERVICE 10 SOCIAL MEDIA 10 ...

BOX CONTENTS 4 mm 6 mm M2,5x6 AX1 Screw (7 pcs) M2,5x4 AX1 Screw (3 pcs) EK-Quantum Vector Strix RTX 3070/3080/3090 Backplate PVC Washer M2.5 (10 pcs) Thermal PAD G 2 mm - (120x24mm) (2 pcs) 120 mm 24 mm Thermal PAD G 1,5mm - (120x24mm) (2 pcs) 120 mm 24 mm 120 mm 24 mm Thermal PAD G 1,0mm - (120x24mm) (2 pcs) 7 mm M2.5 Nut (5 pcs) M2,5x7 AX1 Screw ...

INSTALLING THE BACKPLATE STEP 1 PREPARING YOUR GRAPHIC CARD First complete the installation of your EK-Quantum Vector Strix RTX 3070/3080/3090 water block according to its installation manual. If water block is already installed, remove the six (6) AX1 screws and their PVC washers. Mentioned screws and washers are marked in the image. STEP 2 CUTTING A ...

Once cut to size thermal pads should be applied to the backplate as shown in the image. STEP 2 EK-Quantum Vector Strix RTX 3080: EK-Quantum Vector Strix RTX 3090: Thermal Pad G 1.0 mm Thermal Pad G 1.5 mm Thermal Pad G 1.0 mm Thermal Pad G 1.5 mm Thermal Pad G 2.0 mm ...

STEP 4 ATTACHING THE BACKPLATE Place the backplate on to the PCB aligning all of the holes. Position an M2.5x7 AX1 screw in each of the (6) mounting holed marked below and then tighten them evenly using a Phillips head screwdriver. Do not use excessive force! For this Step, you will need: STEP 4 IMPORTANT DISCLOSURES IMPORTANT NOTICE Once the installat ...

Phillips Head Screwdriver Scissors REQUIRED TOOLS WARRANTY Our products are warranted against defects in materials or workmanship for a period of 24 months beginning from the date of delivery to the final user. During this period, products will be repaired or have parts replaced at our discretion provided that: (I) the product is returned to the agent ...

http://support.ekwb.com/ EKWB d.o.o. Pod lipami 18 1218 Komenda Slovenia - EU EKWaterBlocks @EKWaterBlocks ekwaterblocks ekwaterblocks EKWBofficial SUPPORT AND SERVICE SOCIAL MEDIA ...