elero Ventero-868 Operating Instructions

Commissioning Condition: The end positions of the awning have been set, a transmitter has been taught, and the Ventero-868 has been loaded (LED flashes when a key is pressed) Start teach mode 1. Awning runs up and down for 2 minutes. min. 3 sec. elero 2. 3. STOP STOP Press the “UP” (wind symbol) key immediately after the start of upward travel. Press the “DOWN” (sun symbol) key immediately after the start of downward travel. "Teach-in" programmed transmitter. Checking the function 1. Retracting the awning using the manual transmitter. 2. Set the multiple contact switch for the wind value (at the bottom of the device) to setting 1. 3. Turn the wind vane several times. The awning will retract. 4. Set the multiple contact switch for the wind value to the required setting. Setting the threshold values Multiple contact switches for wind and sun are located at the underside of the Ventero-868. The switch has several settings, which can be modified with a small screwdriver. Wind Setting 1 ➯ Retract at low wind speed Setting 2 to 10 ➯ Intermediate levels Setting 4 ➯ Factory setting Setting 11 ➯ Retract at high wind speeds 11 1 3 9 5 7 Maintenance The Ventero-868 is maintenance-free, although the cover should be cleaned occasionally in order to prevent impairment of the light sensing function. Assembly Before installing the unit at the required position, check the proper function of the Ventero-868 and the receiver. Ventero-868 mounting options The wall bracket can be swivelled between -5° and 180°. Secure the required position once it has been set (see screw a). a Wall bracket rotated 90° Wall bracket rotated 180° Mast and corner mounting (Aero, Aero-868) Optional accessory (Article no. 24 269,0201) 11 1 3 9 5 7 11 1 3 9 5 7 Fault Cause Trouble shooting • Awning • Wind alarm • Wait for wind interlock automatically to be deactivated retracts in (15 min.) or briefly manual mode interrupt power supply. • Ventero-868 is not loaded • Load Ventero-868 • Poor radio connection • Change the position of the Ventero-868 • No travel • Wind alarm is active • Wait (15 minutes) command can be • Battery in the manual • Change battery issued via the transmitter is dead manual • Motor has no power transmitter supply or is overheated • Awning does not • Wind threshold value • Set correct value retract in windy is set incorrectly conditions • Wind vane is faulty

28 190.0001 11 1 3 9 5 7 Device function The wind speed is measured at regular intervals and compared with the set value. Wind value above set value ➩ Awning retracts or remains retracted. The wind function is always active, irrespective of the light switch setting. The slide switch has no influence on the function of the travel keys. However, in the event of a wind alarm, the keys are disabled for 15 minutes. Technical data Power supply Solar Temperature range –25 °C to +60 °C Protection class IP 43 Radio frequency 868,3 MHz Standby ~ 10 hrs. Important! The Ventero-868 only operates in combination with radio recei- vers from the elero ProLine-868 radio system. Loading the Ventero-868 The Ventero-868 is supplied in discharged condition. 1. Prior to commissioning, load the Ventero-868 for at least mini- mum 30 minutes under a lamp or press the travel key for at least 1 minute. Advice: the travel keys have two settings. The first setting transfers energy from a built-in cell to the energy store. The second setting activates the travel command. b b v b b 80 200 135 b b 35 b b 66 GB Warning! Important safety advises! Observe the following instructions. • Only use unmodified original elero electrical parts. • Keep persons away from the operating range of the system. • Keep children away from the controls. • Follow the relevant country-specific regulations. • If one or more devices are used for controlling the system, the operating range must stay visible during operation. • The device contains swallowable small parts. Intended use The Ventero-868 must only be used for controlling roller shutter, awning and blind systems. Third-party devices should only be connected after consultation with your specialised dealer. • Please ensure that the radio installations are not operated in areas of heightened possible interference. (e.g. hospitals, airports . .). • The remote control is only approved for devices and systems for which any malfunction of the manual transmitter or receiver would not result in a risk for persons, animals or property, or if such a risk is covered by other safety devices. • The operator has no protection whatsoever from interferences by other radio emitters and local terminals (e.g. also from radio installations), that are normally used on the same frequency range. • Only use radio receivers with equipment and units approved by the manufacturer. General Ventero-868 is a wireless sun/wind control device for your awning. Integrated solar cells enable autonomous function of the device. Radio signals (frequency 868 MHz) are transmitted between the Ventero-868 and the motor. The awning can be operated manually via a manual/wall transmitter. Safety instructions