BEC BEC 6500AEL Quick Start Manual

1 Package Contents ✓ BEC 6500AEL 4G/LTE Wi-Fi Broadband Router x 1 ✓ This Quick Start Guide x 1 ✓ Wi-Fi Antenna x 2 ✓ RJ-45 Ethernet Cable x 1 ✓ DC Power Adapter 15V DC 1.6A x 1 ✓ 4G/LTE Antenna x 2 ( 6500AEL R18/R21 is using four (4) 4G/LTE antennas) NOTE: ALL IMAGES SHOWN ARE FOR ILLUSTRATION PURPOSE ONLY. PACKAGE CONTENTS MAY DIFFER FROM ACTUAL PRODUCTS. Warning ⚫ Do not use the router in ...

2 Front Panel - LEDs / LTE Connectors PORT MEANING 1 LTE Antenna Connectors Screw the supplied mobile LTE antennas onto the antenna connectors on both sides. (6500AEL R18 / R21 uses 4 LTE antennas and 2 Wi-Fi antennas) LED STATUS DESCRIPTION Power Green System is up and ready Red Boot failure Ethernet Port LAN 1 - 4 Green Transmission speed is at Gigabit speed (1000Mbps) Orange Transmission speed is at 10/100Mbps Blinking Data being trans ...

3 Rear Panel – Ports / Connectors PORT MEANING 1 Wi-Fi Antenna Connectors Screw the supplied Wi-Fi antennas onto the antenna connectors on both sides 1 LTE Antenna Connectors (6500AEL R18 / R21 uses 4 LTE antennas and 2 Wi-Fi antennas) Screw the supplied mobile LTE antennas onto the antenna connectors on both sides 2 SIM Card Slot Insert the mini SIM card (2FF) with the gold contact facing down Push the ...

4 Hardware Connection Back Panel Ports & Connectors Wi-Fi & LTE Antenna Connectors (Standard Version) ...

5 Wi-Fi & LTE Antenna Connectors (6500AEL R18 / R21 Only) Hardware Installation 1. Power Connection Plug in the supplied power adapter to the wall jack, the other side to device then power ON the 6500AEL by pressing the Power On/Off button. ...

6 2. LAN Connection Connect the supplied RJ-45 Ethernet cable to one of the Ethernet ports, and the other side to the PC’s Ethernet interface. 3. WAN Link Interface and Connection BEC 6500AEL supports failover and failback on multiple WAN interfaces, 4G/LTE and Ethernet WAN 3.1 4G_LTE Connection Slide the SIM card into the card slot of the device with the gold contact facing down ...

7 3.2 Ethernet WAN Connection Connect RJ-45 Ethernet cable to the EWAN port, and connect the other side to another alternative broadband device, such as Cable Modem, VDSL, Fiber Modem or PON optic lines. 4. USB for Network File Sharing BEC 6500AEL has built-in FTP and Samba Servers, simply plug in an external USB HD then follow the instruction setup in the User Guide. ...

8 Connecting to the Router The default IP of modem is 192.168.1.254 with subnet 255.255.255.0. Make sure the attached PC to this router is in the same subnet and has an IP address in the range between 192.168.1.1 ~ 192.168.1.253. Open a web browser and type http://192.168.1.254 in the URL address bar. The login prompt will appear. Input the default username (admin) and password (admin) for Account type, Administrator. *This username / pas ...

9 Step 3: Setup Wireless Connection Step 4: WAN / Internet Connection Setup Select the appropriate WAN protocol then fill out the information provided by your ISP in all relevant parameters. Example: WAN Interface in Ethernet WAN (EWAN) mode. Step 5: Save Confirmation Settings Click “Next” to save and complete the Quick Setup. You should now be able to access to the Internet. Please see the relevant se ...

10 Troubleshooting 1. None of the LEDs are on when you turn on the router. Check the connection between the adapter and the router. If the error persists, you may have a hardware problem. In this case you should contact technical support. 2. You have forgotten your router login and/or password. Try the default login and password, please refer to User Manual. If this fails, you can restore your router to its factory settings by holding the ...