BEA WIZARD SMR Operation & User’s Manual

Page 1 of 17 COMBINED SAFETY & ACTIVATION SENSOR TECHNICAL SPECIFICATIONS USERS GUIDE WIZARD SMR COMBINED ACTIVATION & SAFETY SENSOR The Wizard SMR (PN:10WIZARDSMR) combines k-band microwave and focused active infrared technology to provide superior activation and safety for an automatic sliding door system. For activa ...

Page 2 of 17 SAFETY PRECAUTIONS MECHANICAL INSTALLATION COMPONENT ID • Shut off all power going to the header before attempting any wiring procedures. • Maintain a clean & safe environment when working in public areas. • Constantly be aware of pedestrian traffic around the door area. • Always stop pedestrian traf ...

Page 3 of 17 ELECTRICAL INSTALLATION ELECTRICAL INSTALLATION – WIRING 1. With Wizard in place, locate the enclosed cable and feed the stripped end through the wire passage hole in header from the Wizard side as shown in Picture (F). Leave enough slack to allow connection to the Wizard and proper routing of wire arou ...

Page 4 of 17 MECHANICAL ADJUSTMENTS MECHANICAL ADJUSTMENTS MOTION SENSING FIELD 1. The position of the sensing field is determined by the vertical angle of the planar antenna. The angle is adjusted in 3° increments by gently rotating the antenna forward or back. The default mounting angle is 30° - Patterns shown in d ...

Page 5 of 17 BEA’S UNIVERSAL REMOTE CONTROL MECHANICAL ADJUSTMENTS PRESENCE SENSING FIELD 1. Install the desired lens for the infrared curtain (presence), as shown below. • Narrow Lens is suitable for smaller door openings or high mounting height applications. Narrow-field Lens Wide-field Lens [3� ...

Page 6 of 17 WIZARD SMR PROGRAMMING GUIDE – LOCKING & UNLOCKING WIZARD SMR PROGRAMMING GUIDE – INQUIRE ABOUT SETTINGS WIZARD SMR PROGRAMMING GUIDE All program changes and inquiries can only be accomplished while the Wizard is unlocked. UNLOCK LOCK 0-9 0-9 0-9 0-9 Press the UNLOCK key once, then e ...

Page 7 of 17 WIZARD SMR PROGRAMMING GUIDE – Cont. OUTPUT CONFIGURATION The Output configuration has 4 possible output values: 1 = N.O. relay, N.C. transistor 2 = N.C. relay, N.O. transistor 3 = N.C. relay, N.C. transistor 4 = N.O. relay, N.O. transistor 5 = All Relay Output (N.O.) 6 = All Relay Output ...

Page 8 of 17 RAIN MODE SNOW MODE WIZARD SMR PROGRAMMING GUIDE – Cont. RAIN MODE: 1. The Rain Mode is designed to minimize the effect of heavy rain on the Wizard’s auto-learn requirements. Rain Mode will be enabled after the Wizard goes through two auto-learn cycles without having a minimum of 6 operating cycles of th ...

Page 9 of 17 MANUAL SET-UP (without remote) MANUAL SET-UP (without remote) • Set-up of the Wizard may be accomplished by the use of two Wizard mounted programming buttons. The procedures below indicate how to program using these buttons. • The two set-buttons are located at the right side of the Wizard (as viewed whe ...

Page 10 of 17 POWER-UP PROCEDURES TROUBLE- SHOOTING MANUAL SET-UP (without remote) – Cont. EXAMPLE: Change radar sensitivity from 7 to 9 and set hold time to 4 seconds: 1. Press the right button for 2 settings, you will enter the customizing mode • The green LED flashes once (parameter 1) • The red LED flashes 7 ...