Cardinal SB500 Series Installation Manual

1 SB500 Series Remote Display INSTALLATION MANUAL 3601-M418-O1 Rev N 203 E. Daugherty, Webb City, MO 64870 USA Printed in USA 06/15 Ph: 417-673-4631 • Fax: 417-673-2153 www.cardinalscale.com Technical Support: Ph: 866-254-8261 • [email protected] ...

3 TABLE OF CONTENTS INTRODUCTION …................................................................ Page 1 SPECIFICATIONS …………..…………................................... Page 1 SPECIAL FEATURES …......................................................... Page 1 INSTRUMENT COMPATIBILITY …................ ...

4 STATIC ELECTRICITY PRECAUTION CAUTION! This device contains static sensitive circuit cards and components. Improper handling of these devices or printed circuit cards can result in damage to or destruction of the component or card. Such actual and/or consequential damage IS NOT covered under warranty and is the respons ...

1 INTRODUCTION Thank you for your purchase of our Cardinal SB500 Series Remote Display. It was built with quality and reliability. This manual will guide you through installation, and operation of your display. Please read it thoroughly before attempting to install your display. Also, make certain that you pay attentio ...

2 INSTRUMENT COMPATIBILITY Utilizing the Auto-Learn feature, the SB500 display can be driven by the following Cardinal weight indicators and by most weight indicators from other manufacturers. Should configuration be required, Cardinal provides the Smart Configuration software for serial updating of the display. Current M ...

3 SITE PREPARATION Electrical Power The SB500 display has been designed to operate from 90 to 264 VAC at 50/60 Hz. Note that a special order is not required for operation at 230 VAC. WARNING! To avoid electrical hazard and possible damage to the display, DO NOT, under any circumstance, cut, remove, alter, or in any way b ...

4 INSTALLATION Unpacking Before beginning installation of your SB500 display, make certain it has been received in good condition. Carefully remove the display from the shipping carton and inspect it for any evidence of damage (such as exterior dents or scratches) that may have taken place during shipment. Keep the carto ...

5 INSTALLATION, CONT. Continue by lowering the front panel on the display enclosure. Loosen the four captive screws and fully lower the front panel of display exposing the internal circuit boards mounted to the panel and the AC power terminal block and power supply mounted inside the enclosure. See Figure No. 2. Figure N ...

6 AC POWER CONNECTION 1. Referring to Figure No. 3 for an illustration of the gland connectors, bring the AC power into the enclosure. 2. With the AC wiring in the enclosure, remove approximately 1/4 inch of insulation from each conductor. 3. To connect each wire to the AC power terminal block, first loosen each of the thr ...