BAK bakFlip Installation Sheet

Text of BAK bakFlip Installation Sheet

BAK bakFlip Remove the paper backing and apply the seal

strip to the top of the bulkhead. Trim the ends to tightly fit to the sides of the bed. Apply along the radius of the bulkhead back edge. NOTE: Wipe the surface with isopropyl alcohol before applying. NOTE: Installations with a drop-in bed liner will NOT require the bulkhead seal. BULKHEAD SEAL STRIP INSTALLATION INSTALLATION SHEET Parts will be shipped to you directly. Call 818-365-9000 Mon - Fri 8:

DROP IN LINER TRIMMING

If the truck has a drop in bed liner, the top corners at the bulkhead, and the top corners of the tailgate liner need to be trimmed to allow for the bed cover rails. Locate the necessary cuts by starting with the top left corner edge of the liner (1), then measure a distance of 0.18”, 4.8mm, outboard to establish point A. The first cut is down from A 2.5”, 63.5mm, to point B. The next cut is from point A, inboard horizontally 2

BAK bakFlip Identify your truck bulkhead mounting hole configuration.

Follow that letter through the next steps. A A A A A A A- an open hole on top, a threaded hole underneath. B- an open, hex shaped hole on top; an open hole underneath. For vehicles with a sprayed on bed liner, the threaded area in the bulkhead must be cleared of liner material. Thread the buttonhead screw through the #10 oversize washer, through the top hole in the bracket and into the well n

Install the jack nut into the truck bulkhead, one on both sides. Insert the jack nut into the upper, hexagonal hole.

Insert the 1/4-20 bolt through the install wrench and into the jack nut. Use the install wrench to hold the jack nut from turning while tightening the bolt with a wrench or socket. This will pull and collapse the jack nut. Once the bolt has stopped turning, remove it for later installation. Seeing the jack nut from behind is difficult, b

Place the folded cover on the mounted rails at the

front/cab end of the bed. The cab panel holes will align with the slotted brackets of the cover rails. Clean along the full length of the bottom edges of each panel, both sides Clean along the full length of the top rubber surfaces of both rails 15 16 17 Rotate the cab panel down and thread on to the cover mounting bolt the large rubber washer, the large metal washer, the lock washer and thread on the cov

The cover’s aluminum frame will fit just inside the tailgate

when the forward and backward adjustment of the cover is correct. With proper alignment the first two fins of the tailgate seal will be engaged with the tailgate. The rear edge of the cover and tailgate seal will rest on top of the tailgate. If this needs adjustment, loosen the cover mounting knobs and move the cover forward or backward. Be sure to maintain the side to side adjustments made

Tonneau Cover Positions While Operating Vehicle

Prior to vehicle operation, tonneau cover MUST be properly secured. CLOSED POSITION CLOSED POSITION All panels must be closed and FULLY LATCHED to tonneau side rail. All panels must be layed flat and latches engaged. COMPLETELY FOLDED POSITION FLIPPED UP POSITION FLIPPED UP POSITION COMPLETELY FOLDED POSITION To drive with your cover in the completely folded position, engage the provided tie down straps and

BAK® Industries (“BAK”) warrants your BAKFlip Hard Folding Cover to be structurally free from defects in material and

workmanship for the period as outlined in the table below from the retail date of purchase. Warranty registration must be on file and/or proof of original purchase (detailed and dated receipt) required for warranty service. Warranty is non- transferable and applies to the original purchaser of the BAK product only. BAK reser

BAK Automobile Accessories Owners Instructions: