3form SimpleSpec 600.17 Installation Manual
Text of 3form SimpleSpec 600.17 Installation Manual
For more information, please visit 3-form.com or call 800.726.0126
June 2020 | MAn-RTG-600-17 | ReV 003 © 2020 3form, Inc. All rights reserved.
SimpleSpec 600.17
tm
Installation Manual
Ready To Go
9 Channel PWM
DMX Interface
3-60-001
(�1)
Light Drive RGB -
DMX Wall Control
3-60-510
(�1)
100' Patch Cable
3-60-002
(�1)
3M VHB WHITE Tape
3-20-313
(�1)
Required Tools
Clear Silicone
2
For more information, please visit 3-form.com or call 800.726.0126
June 2020 | MAn-RTG-600-17 | ReV 003 ©
16' 4-wire cable with connector also includes
16' cable with mating connector for a total
of 32' to controller. Can be extended up to
50' with 14-gauge wire by electrician.
24"
96"
2"
2"
2"
Provide clearance
in millwork or allow
counter to overhang
⅛"
1⁄16"
2 Apply Adhesives
VHB Tape
Millwork
Make sure Chroma and millwork are free from dirt and debris.
Apply 1"� 1" Piece of VHB tape in six (6) places on millwork .
a
Apply quarter sized dab of clear silicone in six (6) places.
b
4
For more information, please visit 3-form.com or call 800.726.0126
June 2020 | MAn-RTG
Mare sure all tape sticks properly until silicone dries. Tape or clamp as needed to achieve good adhesion.
Place Panel
5
For more information, please visit 3-form.com or call 800.726.0126
June 2020 | MAn-RTG-600-17 | ReV 003 © 2020 3form, Inc. All rights reserved.
SimpleSpec 600.17
tm
Installation Manual
Ready To Go