Sabaj A10d Operation & User’s Manual

安全注意事项 请将本音响系统安装在通风良好、阴凉、干燥、干净的位置，远离直射阳光热源 、振动、灰尘、 潮湿或寒冷。 只能使用本机指定的电压。使用高于指定数值的电压很危险，而且可能导致火 灾，损坏本机或造成人身伤害。对于使用高于指定电压造成的任何损害，深圳 市大号科技有限公司将不负任何责任。 不要试图自行改造或修理本 ...

时钟系统使用了独立的超低时钟抖动 ...

Pre mode.............................................................................................RCA 3.0Vrms THD+N(不计权)............................................ ...

开关机 输入选择 蓝牙 进入菜单/确认 进入二级菜单 返回 静音 音量加/向上 音量减/向下 无功能 ...

A10 d OPTICAL USB L R COAXIAL OUT 9-15V 1 2 3 4 5 6 9 8 7 旋钮 红外接收窗 显示屏 线路输出 同轴输入 光纤输入 USB输入 蓝牙天线 电源输入（DC 9-15V） 6 7 8 9 1 2 3 4 5 ...

2） 短按“旋钮”, 进入菜单, 长按返回主页面 3） 顺时针或者逆时针旋转旋钮, 调节音量大小。 ...

DSD滤波器 前级模式 音色 dF1 (DSD 滤波器1) dF2 (DSD 滤波器2) Pr0 (固定模式) Pr1 (前级模式) SC1~SC3(3种声音风格) bL1~bL3(3级调节) FL1(快速滚降) FL2(慢速滚降) FL3(短延时快速滚降) FL4(短延时慢速滚降) FL5(超级慢速滚降) FL6(低分散短延时) PCM滤波器 亮度 ...

长按: 断开当前设备, 允许配对其它设备 连接: 将输入源切换至蓝牙，打开手机蓝牙功能，搜索 “SABAJ BLUETOOTH”, 搜索到后点击 配对连接，当手机显示“已连接”则已连接成功。 重连: 在使� ...

sources, vibration, dust, moisture, or cold.. Do not attempt to modify or fix this unit. Contact qualified Sabaj service personnel when any service is needed. The cabinet should never be opened for any reason. When not planning to use this unit for long periods of time ( i. e. when going onvacation), disconnect the power cable from the AC wall outlet. When not ...

The unit uses AKM's flagship DAC chip the AK4497, with a well-designed circuit that delivers an unprecedented 0.00012% (-118dB) distortion! The 2nd XMOS solution, PCM supports up to 32bit/768kHz, and DSD supports up to DSD512, custom driver for Native DSD. Qualcomm Bluetooth 5.0 reception, support APTX, better sound quality, longer transmission distance; The clock system uses 2 independent ultra-low cloc ...

Output Level: Fixed mode...............................................................................RCA 2.0Vrms Pre mode..................................................................................RCA 3.0Vrms THD+N(UN-WTD).................................................................. 0.00012% (-118dB) Dyn ...

When using the remote control, point it toward the remote con-trol signal receiver on the main unit from a distance of 5 m (16 ft) or less. Do not place obstructions between the main unit and the remote control. The remote control might not work if the remote control signal receiver on the unit is exposed to direct sunlight or bright light. If this occurs, try moving the unit. Beware that use of this remote contro ...

Optical input USB input Bluebooth antenna Power Supply(DC15V) 6 7 8 9 1 2 3 4 5 Knob Remote window Display LINE OUT Coaxial input HIGH RESOLUTION USB DAC A10 d OPTICAL USB L R COAXIAL OUT 15V 1 2 3 4 5 6 9 8 7 ...

When it is turned on, it will show The display shows when there is no input signal or the sampling rate exceed the range of the unit. When switching input will be displayed (Press the "Input Select" key on the remote control or press the "Power Function" key for input selection) When adjusting the volume, the volume is displayed. The range is maxi ...

DSD FILTER PRE MODE SOUND COLOR BRIGHTNESS dF1 (DSD filter 1) dF2 (DSD filter 2) Pr0 (Fixed Mode) Pr1 (Volume Mode) SC1 ~ SC3 (3 of sound style) bL1 ~ bL3 (Brightness level) FL1(Sharp Roll-off Filter) FL2(Slow Roll-off Filter) FL3(Short Delay sharp Roll-off Filter) FL4(Short Delay Slow Roll-off Filter) FL5(Super Slow Roll-off Filter) FL6(Low Dispersion Short Delay Filt ...

Bluetooth operating instructionst Connection: Step 1: Switch the input source in the SETTING MENU or press the Bluetooth button of the remote; Step 2: Turn on the Bluetooth function of the mobile phone, search for "SABAJ BLUETOOTH", and tap to pairing. When the mobile phone displays "connected ...