Redback A 4314 Operation Manual

Text of the manual

Please follow the instructions in this manual to obtain the optimum results from this unit.

We also recommend that you keep this manual handy for future reference. OPERATION MANUAL 4x120W/4x240W CLASS-D AMPLIFIER A 4310/A 4314 PUBLIC ADDRESS SYSTEM POWER OFF ON 4 x 120W CLASS-D AMPLIFIER A 4310 PEAK SIG CH2 PROT PEAK SIG CH1 PROT CH3 CH4 PEAK SIG PROT PEAK S

1. SAFETY PRECAUTIONS ...............................................................................1

3. FEATURES....................................................................................................3 4. NOMENCLATURE AND FUNCTIONS 4.1 Front Panel ...................................................................................... ...

Be sure to read the instructions in this section carefully before use.

Make sure to observe the instructions in this manual as the conventions of safety symbols and messages regarded as very important precautions are included. We also recommend you keep this instruction manual handy for future reference. Safety Symbol and Message Conventions Safety

An all-pole mains switch with a contact separation of at least 3 mm in each pole shall be incorporated in

the electrical installation of the building. When Installing the Unit Never plug in nor remove the power supply plug with wet hands, as doing so may cause electric shock. When unplugging the power supply cord, be sure

2. PRODUCT OVERVIEW

3.FEATURES 3 The D series digital amplifier is rated from 120W to 500W with balanced signal inputs(H5.08-3 European-style connector) and 100V power outputs (H5.08-2 European-style connector). 1.100V output channel 2.The rear panel is equipped with a "ground" suspension switch to effectively eliminate the loop noise caused by multiple

4. NOMENCLATURE AND FUNCTIONS

4 1. CH1/CH2/CH3/CH4 Volume control of the channel 2. SIG Signal Indicator 3. PEAK Clip Indicator 7. AC Power input 8. Spared (battery) power interface 9. Remote switch, input voltage DC5V~24V 10. Cooling fan 4. PROT Protection Indicator 5. POWER SWITCH Up: turn on the power Down: t

5. MACHINE OPERATION

Amplifier Function The role of amplifiers is to enlarge the audio signal from audio sources, such as MIC, computer and MP3 etc. to boost speaker or pure amplifier to work. Constant Voltage Amplifier The output form of constant voltage amplifier output is constant voltage. It requires a certain load of rated voltage. Constant voltage ampl

4 x 120W CLASS-D AMPLIFIER

A 4310 PEAK SIG CH2 PROT PEAK SIG CH1 PROT CH3 CH4 PEAK SIG PROT PEAK SIG PROT MADE IN CHINA 5378 Figure 1 POWER OFF ON Figure 2 Connect power line AC 240V 50Hz. After the device enter to working status, input balanced audio source signal in the rear panel,adjus

Function Operation of the Panel

Turning master volume control knob on the panel to adjust the volume. Turning clock- wise slowly, volume gets higher; anti-clockwise, volume gets lower until zero level. DC24V backup power (battery) power supply operation In the rear panel of the device DC24V backup power (bat

Loosen the pressure screw.

Put the speaker cable under the wire clamp pad. Tighten the pressure screw and make sure the connection is good. 1. 2. 3. NOTE: 100V output must be connected in parallel with the speakers, and should be connected with the constant voltage speakers, constant voltage speaker is with built-in t

Other Amplifier Manuals