Sakura SSR-L-009 Manual 

User-friendly, Earth-friendly Manual for Controller Sakura Water Source Heat Pump (package) 　 (SSR-L/J-009 ~ 072) R-410a Ref, S- 177 / 07 / 11 ...

KEY FUNCTION …………………………………………………………4 LED INDICATOR…………………………………………………………5 OPERATE GUIDE…………………………………………………………5 ERR CODE AND EXPLANATION …� ...

LED1 LED2 Note：1、The contents with * only displayed on special model uint; 2、Some contents will be changed depend on the setting. Clock display area Room temp display area Mode display area Other display area Fan speed display area Water temp display area Humidity display area OFF ON SUN MON TUE WED THU FRI SAT O M ...

� Quick�start:� � First�step: Press “Mode” key to select a operation mode that want to running.� 1、 “ ”－On/Off�key：� Press once to turn on the system and press once more to turn off the system. Second� step: Press “▲” or “▼” to setting the setpoint temp.� 2、� “M”－Mode�key：� Pre ...

colour indicating on/off status. It will light up if system is on and turn off if system is off. It will flash during system fault. LED2 is yellow colour indicating networking control. It will light up if system is in networking control mode. OPERATION 1、 RTC setting Press “Hour”, “Minute” an ...

configured on the main board, press “Program” once to activate hot water function and screen shows Press “ ” once to activate the energy saving function. Press once more to deactivation this function. Energy saving function will be deactivated automatically when unit is on/off, mode changed and set temp changed. s ...

Should there be system fault on the main board, Please contact with sales or specially trained personnel! green LED flashes apart from showing the error code if the system make fault. Hold down “Set” and “Up” keys for 5 sec to send the fault reset command to the main baord. The explanation of err code shown as below: Err code ...

Step 2: Install the rear cover on the wall by screw. Step 3: Reinstall the panel on the rear cover, screw down the screw on the panel. Step 4: Connect the connecting line of the wallpad to the main board corresponding terminal. rear to mainboard to mainboard to wallpad rear ...