Techne FSC496D Operator's Manual

4 Guarantee 5 OPERATION 6 Preparation 7 Operation 8 ADDITIONAL INFORMATION 9 User maintenance 9 Solvent evaporation temperatures 10 Diagram of gas chamber 12 Replacement parts 13 1 ...

The Techne Sample Concentrator has been designed to provide a quick and convenient method of accelerating the concentration by evaporation of solvents from samples prior to analysis. It is designed to work in conjunction with Techne DB-3, DB-3A or DB-3D Dri ...

OPERATOR SAFETY All users of Techne equipment must have available the relevant literature needed to ensure their safety. It is important that only suitably instructed personnel operate this equipment, in accordance with the instructions contained in this manual and with proper safety standards and procedures. SPECIFICATION Maximum ve ...

reducing valve. The gas pressure should be adjusted as required at the reducing valve but should not exceed 2 psi. Pressure in excess of 2 psi will cause gas to be vented and wasted. 4. Place the Techne Dri-Block® heater onto the base of the Sample Conce ...

the enclosed guarantee card. This period is from the date of purchase, and within this period all defective parts will be replaced free of charge provided that the defect is not the result of misuse, accident or negligence. Servicing under thi ...

other and be positioned centrally. 2. Loosen the locking knob on the carriage. Remove the gas chamber, disconnecting the gas pipe if necessary, and lay the chamber upside down on a suitable work surface. 3. Insert the hyperdermic need ...

Press each needle firmly, pointed end first, through the guide holes and through the sealing pad behind so that it is held firmly in position. Build up the desired pattern of needles to suit the arrangement of test tubes to be used. Do not put a needle in any position which will not have a corresponding sample to ...

Warning - remember high temperatures are dangerous. The heater, insert blocks, sample vessels, needles and samples may be very hot. Always take the precautions listed earlier in this manual. 1. By turning the carriage handle, on the right hand side, counter clockwise raise the gas chamber to take the needles well away from the heater. ...