Tech Controllers EU-293v2 Operation & User’s Manual

I. Safety ............................................................................................................................................................................ 3 II. Device description ............................................................................................................................... ...

3 I. SAFETY Before using the device for the first time the user should read the following regulations carefully. Not obeying the rules included in this manual may lead to personal injuries or controller damage. The user’s manual should be stored in a safe place for further reference. In order to avoid accidents and errors it should ...

boiler controller). Its main task is to maintain the pre-set temperature in the flat by sending a signal to the heating/cooling device (contact opening) when the desired temperature is reached. Advanced ...

5 The EU-293v2 works with an additional EU-MW-3 signal receiver (included in the controller set), mounted near the heating device. Hardware versions: 1. EU-293 B v2 – wireless version, powered with two AAA 1,5V batteries, with a temporary backlight. Colour versions: black or white. 2. EU-293 Z v2 – wireless version, powered with 23 ...

In order to install the device properly, follow the diagram below. A two-core communication cable should be connected to appropriate ports in the receiver. heating device ...

7 The EU-293v2 room regulator may be used as a wall-mountable panel. In order to mount it, place the rear part of the controller in the mounting box on the wall, insert the regulator and turn it slightly. 2. HOW TO INSTALL 230V-POWERED REGULATOR ...

In order to install the device properly, follow the diagram below. A two-core communication cable should be connected to appropriate ports in the receiver. heating device ...

9 IV. WIRELESS CONTROLLER RECEIVER The EU-293v2 regulator communicates with the heating device (or the CH boiler controller) by means of a radio signal sent to the EU-MW-3 receiver. Such a receiver is connected to the heating device (or the CH boiler controller) by means of a two-core cable, and communicates with the room regulator usi ...

1. Insert the batteries - in order to do it, remove the front cover (battery-powered version). 2. If the room regulator is to control the floor heating system, connect an additional sensor to the floor sensor co ...