OJ ETO2 Operation & User’s Manual
Text of the manual
57652F 08/11 (MBC)
© 2011 OJ Electronics A/S
English
page
2
Deutsch
page 18
Polski
page 35
Русский
page 52
Type ETO2
Controller for ice
and snow melting
MANUAL
GREEN COMFORT
Maximum comfort with low energy consumption
© 2011 OJ Electronics A/S - ® The OJ trademark is a registred trademark belonging to OJ Electronics A/S
CONTENTS
Glossary. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page
2
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page
3
Startup . . . . . . . . . . . . .
Type ETO2 is an electronic controller for fully automatic, economical ice and snow melting on outdoor areas
and in gutters. Ice forms due to a combination of low temperature and moisture. ETO2 detects both
temperature and moisture and the heating system will only be activated if a possibility of snow or ice is
indicated by both parameters.
An ea
When ETO2 is switched on for the first time, Celsius or Fahrenheit must be selected.
Turn the encoder button until the required temperature scale is highlighted. Then OK
the selection by pressing the encoder button.
SENSOR 1 is shown on the display, allowing the type of sensor connected for input 1
to be selected:
ETOG : Ground sensor
Select if outdoor sensor ETF is connected terminals 31-32.
If none sensor ETF is connected, OFF must be selected. Press encoder button for OK.
Select the application type by turning the encoder button and pressing OK.
ELECTRIC 1-ZONE : 1 zone electric heating control/simple waterbased.
ELECTRIC 2-ZONE : 2 zones individual electrical heating control/simple wa
ETO2 is equipped with an easily operated encoder button (turn and press) and a display which describes the
current situation. The display is backlit and is illuminated by pressing the encoder button (OK). The
illumination is automatically switched off after 30 seconds.
Press the encoder button and the main menu will be shown on the display.
Turn th
Heating zone 1 active (ON) or inactive (OFF)
Heating zone 2 active (ON) or inactive (OFF)
Sensor 1 (heated sensor) core temperature. Applies only when ETOG sensor is
connected. NOTE: Not ambient temperature!
Sensor 2 (heated sensor) core temperature. Applies only when ETOG sensor is
connected. NOTE: Not ambient temperature!
Sensor 1 moisture st