Ninglu SIM990 Operation Manual
Text of the manual
Doc No: NLT-SIM990-SSEN
Version: V180126
NINGLU SIM990
Echo Sounder &
Transducer Tester
Operation Manual
Introduction .............................................................. 1
Features ........................................................................... 1
Packing list ........................................................................ 1
Button description ................................................................ 2
Specification
SIM990 is a handheld portable tester for echo sounder and transducer.
Echo sounder tester
The SIM990 can measure the output of an echo sounder, and if required,
reply with a user defined signal to simulate operation of the transducer.
Transducer tester
The SIM990 is a tester that measures the characteristics of the transducer,
showing the reso
Yellow flashing:There are input pulses, which is to have been connected with
echo sounder/ fish finder with power on.
Red flashing: There are output single, which is to send to bottom/fish signal.
Power on/off: Turn on/off the system.
Operation Area:
To move the cursor position
To set values
To echo transmit/
128×64 dot-matrix LCD
Dimension:
235mm×135mm×55mm
Weight:
750g (1.2 kg with bag and cables)
Power supply internal:
Rechargeable li-ion battery (12.6 V DC)
Power supply external:
12.6 V/350 mA operation and battery charging
Built-in battery:
12.6VDC 1500mAh
Battery charger:
12.6V/350mA
Working temperature:
10 kHz - 999.9 kHz
0.01 kHz
±0.1 kHz
Resonant frequency
Fr
10 kHz - 999.9 kHz
0.01 kHz
±0.1 kHz
Resonant impedance of the transducer
Zr
1 ohm - 65 535 ohm
1 ohm
±1 ohm
Resonant phase of the transducer
Qr
0~3.14
0.01
±0.01
Transducer impedance at the specified frequency
Zt
1 o
from echo sounder before testing!
Auto self-test
On startup, the screen will show the system firmware version.
Main menu
After the auto self-test procedure, the SIM990 MAIN MENU appears.
The SIM990 also shows the battery status. The battery should last about 4
hours for transducer tester and shorter for simulator.
1.1. INPUT MEASURE
1.2. AUTO TRACK
1.3. BOTTOM SET
1.4. DEMO
2.1. Tran tester
SIM990 Menu Structure
1 Echo
simulator
2 Tran
tester
1. Freq
2. Width
3. Period
4. Ampl
1. Freq
2. Width
3. Ampl
4. Depth
5. Rply
1. Freq
2. Width
3. Depth
4. Rply
1. Ratio
2. Width
3. Depth
1
2
3
4
1. Sfreq
2. Efreq
3. Step
1 Echo simulator
Connect SIM990 to the echo sounder’s transducer input/output interface. The
echo simulator is used to verify that the transceiver electronics is working
satisfactory. This should be used if the system seems to have shorter range
than normal, if there is too much noise on the screen, or if the system looses
the bottom.
Important, warning: