Ninglu SR362 Operating & Installation Manual

Text of the manual

Doc No.: NLT-SR362-SSEN

Version: V140301 NINGLU TECHNOLOGY CO., LTD. 105-2 Da Ming Road Nanjing City, China Phone: 86-25-52614640 ext. 8820 URL: http://www.sounder.com.cn NINGLU SR362 Steering Repeater Operating & Installation Manual

Steering repeater SR362 ensures a clear indication of the heading

information by using a 360°compass card. Brightness is adjusted on the front panel, via NMEA or from the optional remote controller, DIM930. Multiple installation methods facilitate observation in different positions. Features � NMEA0183 gyro signal input � 1°reading accura

218 (L) × 202(W) × 64(H) mm

Flush mounting window size: 170×170mm (6.693×6.693 inch) Weight: about 2Kg Supply voltage: DC18~36V reverse-polarity and over-current protection Power consumption: ≤ 8.4W(DC 24V) Indication range: 0 ~ 359° Reading accuracy: ±1° Data format: NMEA0183 sentence $--HDT,x.x,T*hh

6-level adjustable LED backlight

②Indicating arrow Indication of the heading ③Signal light: Indication of working status 1. Normal mode: Signal monitor Signal correct: green (continuous) Signal incorrect: red (flash) 2. Manual calibration mode: red/ green (flash) (Refer to Manual calibration in page 4 for det

1. Boot-strap (self-calibration)

Connected with MEA0183 gyro signal and power supply, SR362 will auto start self-calibration to 0° while signal light is red (continuous). ATTENTION! Please avoid direct sunshine during self-calibration! Otherwise it may cause calibration failure. 2. Common mode When self-calibration, unit auto identify the NMEA01

3.3 Turn into common mode

After calibrating to 0°, stop all operation, then the signal light will flash quicker and quicker until be green (continuous) which means common mode. REMOTE DIMMER (optional) DIM930 can is used for remote control of the SR362 backlight. WIRING Supply voltage: DC24 (DC18V~DC36V)

The unit can be mounted in panel, table, wall or ceiling.

1. For tabletop mounting, wall or ceiling mounting use the supplied bracket. 2. For panel (flush) mounting, take off the bracket and take off the front frame. Cut a 170x170mm(6.693×6.693inch) size square window in the panel, fix the inside 4 holes with tapping screws, and put on the fr

Other Repeater Manuals