Hyster D435-R1.4 Technical Information

Text of the manual

Technical information for Hyster service

centres This manual is intended solely for the specialized technicians of the Hyster service network. 4065749 D435..... R1.4 R1.6N R1.6 R1.6HD R2.0 R2.0HD R2.5

The Service Manuals are updated regularly, but may not contain the most recent product design modifica-

tions. The updated technical information is in any case available from your nearest authorised Hyster® dealer. The Service Manuals provide the guidelines for correct maintenance and are designed for use by appropriately t

This handbook is composed of the following sections:

Section 1: Presentation Section 2: Installation and settings Section 3: Diagnostics and measurements Section 4: Electrical system Section 5: Hydraulic system Section 6: Truck base mechanics Section 7: Mast assembly mechanics Section 8: Small fork mast mechanics Secti

GENERAL SAFETY RULES

PERSONAL SAFETY Always wear the personal protective equipment in situations requiring it. • Pay particular attention to the risk of getting crushed due to moving parts, oscillations, material not • properly secured when performing lifting operations or moving loads. Do not wear any rings, watches, jewellery, lo

Before using the batteries, make sure that both ends of the cables are connected to the terminals as

• prescribed: (+) with (+) and (-) with (-). Do not short-circuit the terminals. • The gas released when charging is highly flammable. When charging, leave the battery compartment • uncovered for more effective ventilation and tak

Thanks very much for your reading,

Want to get more information, Please click here, Then get the complete manual NOTE: If there is no response to click on the link above, please download the PDF document first, and then click on it. Have any questions please write to me: [email protected]

Belt capacity table

Rope capacity table Colour Track (mm) Working load capacity (kg) black 35 500 1000 700 400 purple 50 1000 2000 1400 800 black 50 1500 3000 2100 1200 green 60 2000 4000 2800 1600 yellow 75 3000 6000 4200 2400 grey 120 4000 8000 5600 3200 red 150 5000 10000 7000 4000 brown 180 6000 12000 8400 4800 blue 240 8000 16000

Suspension element capacity table

Colour Working load capacity (kg) purple 1000 1400 2100 2100 green 2000 2800 4200 4200 yellow 3000 3800 6300 6300 grey 4000 5600 8400 8400 red 5000 6600 9800 10500 Coefficient 1 1.4 2.1 2.1 Working load capacity: the working load capacity is calculated with an angle at the centre of 90°

TORQUE SETTINGS FOR SCREWS, NUTS AND FITTINGS

Before disassembling the various parts and nuts and bolts, read the following carefully. To make the threaded matings secure, LOCTITE 270 is used for tightening the screws. If it is not possible to unscrew the bolts because this product has been used, avoid applying extensions to the tools,

CORRECT METHOD FOR APPLYING FEMALE FITTINGS

To assure a reliable seal between female fittings and the adapters in this manual, it is necessary to observe the following procedure, which differs from the one for assembling rigid pipes. Female fittings without a gasket (metal/metal joint) Screw on the nut by hand and then, with the aid of

Other Forklifts Manuals