National Instruments REM-11178 Getting Started Manual

Text of National Instruments REM-11178 Getting Started Manual

GETTING STARTED GUIDE

NI REM-11178 Digital Output Module for Remote I/O This document explains how to connect to the REM-11178. Note The guidelines in this document are specific to the REM-11178. The other components in the system might not meet the same safety ratings. Refer to the documentation for each component in the system to determine the safety and

Isolation Withstand Voltages

Test section Test voltage 5 V communications power (logic), 24 V supply (I/O) 500 VAC, 50 Hz, 1 min. 5 V supply (logic)/functional earth ground 500 VAC, 50 Hz, 1 min. 24 V supply (I/O)/functional earth ground 500 VAC, 50 Hz, 1 min. Electromagnetic Compatibility Guidelines This product was tested and complies with the regulatory r

Verifying the Kit Contents

Verify that the following items are included in the REM-11178 kit. Figure 1. REM-11178 Kit Contents 1 2 3 4 1. NI REM-11178 2. Bus connector 3. Supply voltage connector 4. Spring-terminal block (x4) Unpacking the Kit Caution To prevent electrostatic discharge (ESD) from damaging the device, ground yourself using a grounding strap

Installing the REM-11178

Figure 2. Structure of the REM-11178 1 2 4 6 5 3 1. Bus connector 2. REM-11178 3. Module function label 4. Supply voltage connector 5. Spring-terminal block 6. LED indicators Table 1. Module Function Labels Label Color Module Function Blue Digital input Red Digital output Green Analog input, thermocouple Yellow Analog output White Bu

Insert the bus connector for the REM-11178 into the DIN rail.

Caution Verify that you are using the correct bus connector for the module width. 2. Slide the bus connector along the DIN rail until it connects to the preceding bus connector. Note A bus connector will not attach to a preceding bus connector with a mounted module. Remove the preceding m

National Instruments Control Unit Owners Instructions: