GTO F300 Instructions

The first thing you need to do is set the dip switch settings in your remote transmitter and go through the "learn" process with the circuit board. You can do this by doing the following: 1. Pop the cover off your remote transmitter. 2. Scramble the nine dip switches above the 9vdc battery. 3. Turn the gate opener off using the switch on the outside of the black control box. It is on the bottom of the box in the middle near the rear of the box. 4. Locate the learn button in the lower right hand corner of the circuit board. - 1 -

6. Once the gate opener is on, release the learn button. 7. Hold down the button on the push button remote until the red status light comes on. At this point, you should be able to operate your gate with the transmitter. Once the transmitters are working properly, then we need to program the keypad to operate the same as your transmitter. To do this, we are going to notice how the nine dip switches are set on your transmitter and program those settings into the keypad using the 1, 4, and 7 keys on the keypad when we get to this step in the programming. - 2 -

the 4 key on the keypad. If the dip switch is set to -, then press the 7 key on the keypad. In this way, we will press either a 1, 4, or 7 on the keypad for all nine dip switches on the transmitter. To program the keypad to your transmitter, do the following: 1. Take one of the batteries out of the back of the keypad. 2. Hold down the 3, 6, and 9 keys all at the same time. - 3 -

keypad to the factory settings. 4. Press the programming button located in the lower left hand corner. 5. Press 1, 2, 3, & 4 in sequence. 6. Press the programming button. 7. Press 0. 8. Press the programming button 9. Press the 1, 4, or 7 keys to program the dip switches from the transmitter. 10. Press the programming button. - 4 -

At this point, you should be able to open your gate by entering the factory code, 1,2,3,4. To program the personal master code, do the following: 1. Press the programming button. 2. Press the keys 1,2,3,4 in sequence. 3. Press the programming button. 4. Press 1. 5. Press the programming button. 6. Enter your personal master code. It can be any number between 3 to 6 digits in length. 7. Press the programming button. At this point, you should be able to operate the gate by using your personal master code and the factory code 1,2,3,4 should no longer work. To program up to 15 different entry codes: 1. Press the programming button. 2. Enter the personal master code. 3. Press the programming button. 4. Press 2 for the second code, 3 for the third code, etc. 5. Press the programming button. 6. Enter the entry code. 7. Press the programming button.