jbc AL251 Manual 

AL-9A / AL-2AA SOLDER FEED STATION AL-SC STAND AL251-A SOLDERING IRON Power cord socket Equipotential connection 0964551 Pedal (optional) AL251-A SOLDERING IRON 0780493 ALLEN AL251 / SOLDERING IRON INSTALLATION AL250 SOLDERING IRON AL251 SOLDERING IRON www.jbctools.com

- Place the cartridge in the solder feed handle. Important: It is essential to insert the cartridge till the end for a good connection. Use the mark as reference. - Align the tip of the cartridge with the solder guide tube (3). Tighten the cartridge screw (1). WARNING: It is esential to tighten (1) screw for the tool to function. - You must leave a gap of 8-10 mm between cartridge tip and the end of the guide tube (2). Loosen the guide screw (4). Adjust the guide tube and tighten screw (4). CHANGING THE HANDPIECE’S CARTRIDGES AL-IA HANDS-FREE SOLDERING ARM AND FUME EXTRACTOR F4468 FUME EXTRACTOR ACCESSORIES 1 2 4 3 8-10 mm Cartridge screw Guide tube screw Alignment

facturing defects, covering the replacement of defective parts and all necessary labour. Warranty does not cover product wear due to use or mis-use. In order for the warranty to be valid, equipment must be returned, postage paid, to the dealer where it was purchased enclosing this fully filled in, sheet. www.jbctools.com SERIAL Nº STAMP OF DEALER DATE OF PURCHASE 0011700-0812 This product should not be thrown in the garbage. All the cartridges shown are actual size. Consult our wide range of cartridges with more than 250 references in www.jbctools.com For special cartridges contact with our distributor. C250 CARTRIDGE RANGE ø 0,6 1,8x0,8 ø 0,8 4,8x1,5 1,2x0,7 3,2x1,5 ø 2,2 2,2 x 1 1,2x0,7 2,2x1 4,8x1,5 ø 2,2 ø 3,8 2,2x1 ø 1,7 ø 1 C250-401 C250-405 C250-402 C250-406 C250-403 C250-412 C250-404 C250-418 C250-409 C250-410 C250-413 C250-407 C250-408 C250-411 C250-414 C250-415