CyberPower CP1300EPFCLCD Operation & User’s Manual

This manual contains important safety instructions. Please read and follow all instructions carefully during installation and operation of the unit. Read this manual thoroughly before attempting to unpack, install, or operate your UPS. CAUTION! The UPS must be connected to a grounded AC power outlet with fuse or circuit breaker protection. DO NOT plug the UPS into an outlet that is not grounded. If you need to de-energize th ...

cause the UPS unit to shut down or the circuit breaker to trip. BASIC OPERATION DESCRIPTION 1. Power Switch Used as the master on/off switch for equipment connected to the battery power supplied outlets. 2. Power On Indicator This LED is illuminated when the utility power is normal and the UPS outlets are providing power, free of surges and spikes. 3. LCD Modu ...

temporary uninterrupted operation of your equipment during a power failure. (DO NOT plug a laser printer, paper shredder, copier, space heater, vacuum, sump pump or other large electrical devices into the “Battery and Surge Protected Outlets”. The power demands of these devices may overload and damage the unit.) 12. Full-Time Surge Protection Outlets The un ...

CyberPower’s Green Commitment CyberPower is dedicated to the development of green products, and has adopted Green practices throughout its business, including: membership in Climate Savers Computing Initiative (CSCI), accordance with the Restriction on Hazardous Substances (RoHS), Waste Electrical and Electronic Equipment (WEEE) protocols, as well as ISO 14001 and IECQ QC080000. CyberPower pledges to provide the ...

9. Put the batteries back into the compartment. 10. Slide back the battery compartment cover and tighten the retaining screw. 11. Recharge the UPS for 8-16 hours to fully charge the battery. REMINDER: Batteries are considered HAZARDOUS WASTE and must be disposed of properly. Almost any retailer that sells lead-acid batteries collects used batteries for recycling. CP1300EPFCLCD CP1500EPF ...

UPS’s internal battery. During a blackout or severe brownout, the UPS switches to battery power, the BATTERY icon appears, and the charge level decreases. 6. FAULT: This icon appears if there is a problem with the UPS. Press the POWER button to turn off the UPS. F01: Battery Mode or AC/Utility Power Mode Overload fault (Turn on the UPS again.) F02: Battery ...

AVR Function Yes Output On Battery Output Voltage 230Vac +/-10% On Battery Output Frequency 50/60Hz +/-1% Overload Protection On Utility: Circuit Breaker, On Battery: Internal Current Limiting Surge Protection Lightning / Surge Protection Yes Network/ Phone/ Fax/ Modem Protection RJ11/RJ45 ( One In/ One Out ) Oper ...

projecting from the back of the unit. Circuit breaker has tripped due to an overload. Turn the UPS off and unplug at least one piece of equipment. Wait 10 seconds, reset the circuit breaker by depressing the button, and then turn the UPS on. The UPS does not perform expected runtime. Battery not fully charged. Recharge the battery by leaving the UPS plugged in. Battery is slightly ...