Major MT 730 Instruction Manual

Text of the manual

1. Measuring Limits ........................... 1

2. Safety Warnings ............................ 2 3. Features ......................................... 4 4. Instrument Layout ......................... 5 5. Specifications ................................ 5 6. AC Current Measurement ............. 7 7. DC Voltage

2. SAFETY INFORMATION

This manual contains information that must be followed for operating the meter safely and maintaining the meter in a safe operating condition. If the meter is not used in a manner specified in this manual, the protection provided by the meter may be impaired The Model MT730 has been designed and complies with IEC 61010-1 and EN 61

! Never use the meter to measure voltages on a

circuit above the maximum allowable input value on any function. ! Do not exceed the maximum allowable input of any measurement range. ! Never touch exposed wiring, connections or any live circuit when attempting to take measurements. ! Do not attempt to make measurements in flammable gaseous areas, f

! Before making measurements ensure that the

function selector switch is set on the appropriate range position. ! Always make sure that the plug of each test lead is inserted fully into the appropriate terminal of the meter. ! Ensure that the function selector switch is set to the “OFF” position after use. When the meter will not be in use for

4. INSTRUMENT LAYOUT

Transformer Jaws Jaw Trigger Backlight Switch Max Hold Switch Display COM Terminal AC Volt, DC Volt Resistance, Buzzer and Diode Test Input Terminal Data Hold Switch Range Selector Switch for Volts and Resistanc 5 Buzzer and Diode Test Switch

Accuracy (% of Reading)

± (2.5% + 10 digits) ± (2.5% + 10 digits) ± (3.0% + 8 digits) Range DC Voltage Measuring Range Resolution 200mV 2V 20V 200V 600V 0 ~ 200.0mV 0 ~ 2.000V 0 ~ 20.00V 0 ~ 200.0V 0 ~ 600V 0.1 mV 0.001 V 0.01 V 0.

6. AC CURRENT MEASUREMENT

WARNING: Ensure that the test leads are disconnected from the meter before making current measurements. 1. Set the function switch to or or range position, and make sure that the current under test does not exceed the upper limit of the measuring range you have selected. 2. Press the trigger to open up

Other Measuring Instruments Manuals