GRAUPNER MC-20 HoTT Programming Manual

Code lock ...................................................... 31 Secret mode .................................................. 32 Display contrast ........................................ 32 Language selection Voice update............................................. 32 Change of display language ..................... 33 Firmware upda ...

2/4 ailerons and 1/2/4 camber fl aps .................168 »Helicopter mixer« .............................................. 176 Adjusting the throttle and pitch curve ............... 187 Autorotation setting ........................................... 190 General remarks about freely progr. mixers .......... 192 »Free mixers« ....... ...

please read these instructions thoroughly and give particular attention to the safety notices. You should also register right away at https://www.graupner.de/ de/service/produktregistrierung.aspx since this is the only way for you to automatically receive current information about your p ...

control is at its Stop/Idle position. Always switch the transmitter on fi rst and then the receiver. Always switch the receiver off fi rst and then the transmitter. If this sequence is not maintained, such that the receiver is still switched on when the corresponding t ...

The rule: "capacity is reduced with every successive recharging", applies to all batteries. Internal resistance increases at low temperatures to further reduce capacity. As a consequence, the battery's ability to provide current and hold its voltage is reduced. Frequent charging or the use of battery maintenance p ...

with diverse regulations like FCC, ETSI, CE etc. Follow the respective instructions provided for this with the transmitter and receiver. Prior to every fl ight, perform a complete functional • test, range test and execute a complete simulated fl ight in order to exclude the possibility o ...

• permanently and is therefore to be avoided absolutely. The mc-20 HoTT transmitter switches itself off when its power supply voltage reaches its lower limit of 3.3 V. Short circuit conditions are to be avoided absolutely. Permanent short circuits lead to destruction of the battery, high tempe ...

• removed from that equipment when it is not currently in use. Alway switch off equipment after it is used to prevent deep discharging. Always charge batteries before it is too late. Store batteries on a non-combustible, heat resistant, non-conducting surface! Deep-discharged LiIo-/Li ...

The technical advances across the entire spectrum of model building is an ever-present challenge to design engineers. This is why the introduction of new transmission technology in the 2.4 GHz band represents a new milestone. The HoTT-System (Hopping Telemetry Transmission) developed by G ...